AVteq TC8-WMP User manual

Install Guide
TC8-WMP

800-285-8315 AVTEQ.net
1
2
A) Place the face plate face down on a table.
B) Slide the touch panel into the "U" shaped
channel on the back of the face plate in front of
the flange.
C) Tighten 1/4-20 screws on flange until they
touch the TC8. Do not overtighten. The touch
panel should sit in the bottom of the channel in
the flange.
E
Place the wall box over the back of the
face plate lining up the four holes on
the faceplate.
C)

800-285-8315 AVTEQ.net
3
4
E
Place L bracket into the top of the wall box. Use
the L bracket to secure the touch panel snuggly to
the front of the face plate and then secure in place
with 1/4-20 screws provided.
Remove the wall box with the L bracket
in place from the face plate. Place the
wall box in the wall. Secure with either
wall anchors on the front flanges or
directly to a stud.
Note: The cutout for the wall needs to
be 9.5" wide and 6" tall.
secure with wall anchors
secure to studs

800-285-8315 AVTEQ.net
5
Slide the face plate into the
wall box and secure with four
1/4-20 screws