
Configuring
2
www.aim-sportline.com Release 1.01 – November 21st 2018
1.1 – Physical connection
To physically connect the devices, use SmartyCam CAN cable; available versions are:
•SmartyCam CAN cable: length 2m: V02566070
•SmartyCam CAN cable: length 4m V02566060
Each AiM device is equipped with a connector or a cable labelled “EXP” that is to be connected to
SmartyCam “EXT” connector:
•SoloDL/Solo 2 DL: connect SmartyCam CAN cable to the 5 pins connector placed under the
device
The 7 pins connector is used to connect with the vehicle ECU (via CAN, K-Line or RS232) and the
external power source
•EVO4/4S: connect SmartyCam CAN cable to the connector labelled “Exp”
•EVO5: connect SmartyCam CAN cable to the cable labelled “EXP” of 37 pins connector harness
included in the kit
•MXL2, MXS 1.2, MXG1.2/MXP: connect SmartyCam CAN cable to the cable labelled “EXP” of 37
pins connector harness included in the kit
•MXS 1.2 Strada/MXG 1.2 Strada/MXP Strada: connect SmartyCam CAN cable to the cable
labelled “EXP” of 14 pins connector harness included in the kit
•MXL Strada/Pista: connect SmartyCam CAN cable to the 5 pins connector placed rear right of the
device
•MXL Pro05: connect SmartyCam CAN cable to the cable labelled “EXP” of 22 pins connector
harness included in the kit
•ECU Bridge: connect the camera CAN cable to 5 pins connector of the device.
If you need to connect more expansions we suggest to use a Data Hub – AiM CAN connections
multiplier – available in different versions with different part numbers:
•two ways Data Hub with 40 cm cable: X08HB2GK0
•four ways Data Hub with 40 cm cable: X08HUB010
•four ways Data Hub with 150 cm cable: X08HUB150