OS-EC-230V
Product Information & Installation Guide
ONYX SERIES - Model EC
saving you energy
UNIT PLACEMENT
VELOCITY PROFILE
PREPARATION
Install electrical circuit(s) and outlet(s) in accordance with naonal
and local electric codes.
Outlets should generally be mounted vercally unless a “twist/
locking” type is being used.
Wall switch may be installed in circuit to disable power and
prevent electrical hazards when servicing.
Confirm electrical connuity of Airius unit on the ground before
permanently mounng in the ceiling.
OPERATION
Designed to operate 24 hours-a-day, 7 days-a-week to maintain
air circulaon/thermal equalizaon/humidity equalizaon.
Use oponal speed control to fine tune RPM if needed.
MAINTENANCE
Frequency of cleaning will vary by applicaon and environment.
You may clean the plasc housing with a damp warm cloth, using
mild household detergents.
Do not use petroleum products, thinners or solvents to clean any
part of the Airius unit.
If the Airius unit fails, contact manufacturer.
MATERIALS & PROPERTIES
Constructed from recyclable materials.
The outer shell, stator and fan blades are fire rated 5VA materials.
Power cord is a 1.8m, 3 wire, 1.02 mm diameter 300VAC rated
electrical cord - CE/EU compliance rated as HO5VV (PLUG NOT
SUPPLIED).
Electrically commutated, variable speed 92% efficient motor.
Motor is thermally protected. Shutoff is at 110°C & reset is at
90°C.
No lubricaon required. Bearings are sealed.
INSTALLATION
Do not hard connect fans in excess of 10 kgs unless agreed with
Airius prior to Installaon. When aaching it is preferred if some
chain or cable is used between fan and the support. However it is
not imperave.
For Cooling the Airius fan should be located to suit client’s
requirements. Suggested locaons are from just under the ceiling
or closer to the floor to ensure suitable air-cooling flow.
For Heang or Condioned Spaces the Airius fan should be
securely installed as close as possible to the ceiling.
For combinaon applicaons fans can be installed close to ceiling
or lowered slightly. Contact Airius for design details and assistance.
The Airius unit performs best when air column from the nozzle is
unimpeded to the floor.
The Airius unit should not be mounted directly in front of heat
ducts, vents or any other high heat source.
Use professionally installed hardware, capable of supporng a
minimum of five mes the weight of the fan unit.
Hardware to hang the unit includes but is not restricted to: Hooks,
chains, cables, carabiners, bridle rings, beam clamps and bolts.
Density of the placement is directly related to the effecveness,
performance and savings.
Mount out of reach from people and animals.
Floor plans, mezzanines, office locaons, machinery, people
placement, plumbing, lighng, duct work, electrical systems, natural
light/air systems, cranes, doors, windows, venlaon and fire
suppression systems are all factors in properly locang the Airius
system within the ceiling.
1.5 m
(5 ft)
(5 ft)
1.5 m
0
> 1.31 m/s
(257 ft/m)
> 0.91 m/s
(179 ft/m)
> 1.81 m/s
(356 ft/m)
> 0.69 m/s
(135 ft/m)
> 2.78 m/s
(547 ft/m)
9 m
(30 ft)
6 m
(20 ft)
3 m
(10 ft)
18 m
(60 ft)
15 m
(50 ft)
12 m
(40 ft)
