6
OPERATION GUIDE
COOL :Set operation diverter switch on this site and COOL” light comes
on. Use button “UP” and “DOWN” to set the temperature required.
If the temperature of room is higher than that selected ,the appliance acti
-vates cooling. The compressor starts after a delay of 3 minutes(during
which only the ventilation function is active)
If the temperature of room is lower than that selected required,the applian
-ce activates ventilation function.
DRY :Press MODE button to select DRY and “DRY” lamp comes on.
If the temperature of room is higher than 13 C/54 F the compressor will start
and stop alternately.Fan keeps at low speed when the compressor is running.
If the temperature of room is lower than 13 C/54 F , the compressor and fan
will stop.
O
FAN : In this mode only indoor fan motor runs.
At this moment, the unit acts
as a fan only.
Setting Temperature
Press “UP” or “DOWN” button to regulate the temperature required(rang
-ing from 16 C to 31 C/60 F to 90 F).The display window will show the
temperature you set as you press “UP” or “DOWN” button.Otherwise,it
will always show the ambient temperature.
OOOO
Setting ventilation speed
Press FAN button to choose the ventilation speed you need,high,middle
or low.The display lamp of high,middle or low ventilation will be on at the
same time.
If the unit is in COOL mode,choose auto-ventilate on remote controller it
will choose the ventilation speed automatically according to the ambient
temperature (the related display lamp will be on).
Setting timer
When air conditioner is running, each time press TIMER button then press
UP or DOWN button, 1~24HR timed off time can be set as required(The
“Timed time display lamp” will be on).The appliance will turn off automa
-tically when time reach the setting value.
When air conditioner is not running, each time press TIMER button then
press UP or DOWN button, 1~24HR timed on time can be set as required
(The “Timed time display lamp” will be on).The appliance will turn on auto
-matically when time reach the setting value.
If you want to cancel timing anytime,press ON/OFF button on control
panel ,or press TIMER button on remote controller or control panel again.
Sleep function
By pressing the SLEEP button,the set temperature will increase 1 C/2 F
in an hour ,then maintain that temperature for the balance of the time set.
Re-press the SLEEP button,the setting temperature will return to the
pre-selected one.
OO
O
O
O
