ENGLISH
For you attention
Thank you for choosing HomeTheater Speaker System SS003A-310. Beforeattempting to connect
and/or operate thisHome TheaterSpeaker System, pleaseread the followinginstructions and keepthis
manual for futurereferrence.
Caution!
Do not placesources of nakedflames, such as lighted candles, on the unit.
Use a damp cloth for cleaning. Do not use liquid or aerosol cleaners.
Do not placeheavy objects ontothe top of this unit.
Service:
Do not try to eliminate breakages by your own. Should the sound is out, the smoke appears or any
other troubles takeplace, which werenot mentioned in this manual, please call your dealeror service
center.
Warning:
Do not opencovers and donot repair yourself. Refer servicing to qualified personnel.
Operation instructions
Placement of speakers
Speaker placement is very important. Please place the front speakers at least 2 metres apart
left and right of centre speaker. The centre speaker should be placed on top or below the TV,
facing you. The rear speakers should be placed behind your seating position about a half and a
meter to the left and to the right. There are rooms where it is impossible. To compromise place
the rear speakers at the back of the room, facing your seating position.
Speaker wire
Use good quality speaker wire around 1.5 to 2mm in diameter with a trace or marking on
the plastic coating to determine which is the positive wire. This is very important, because if
you connect your speakers red to black on 1 speaker you will have what we call (out of phase).
You must ensure that positive + of the amplifier goes to positive +on the speaker. If you connect
the wrong way it will reduce the bass response and change the characteristics of the speakers
sound.
Banana plug connectors
The terminals on the front speakers have banana plug sockets. You can purchase banana
plugs from your store that fit the wire and plug directly into the sockets on terminals. There is
also a large diameter hole under the terminal. If you are not using banana plugs cut the coating
from the wire about 15 mm, unscrew the terminal, push the wire through the hole and do the
terminal up tight. Make sure that all terminals are tight properly. If they are loose this can cause
a static type of sound.
Standard speaker connection
Connect red + from your receiver to red + on the speaker and black - to black - the same
way. Connect the center and rear surround speakers to the connections as shown on the Receivers
instructions.
