Akzu Sprite X3 Series User manual

Warning and safety instructions
1. Only interior using for this type of luminaire.
2. Main voltage supply must be disconnected or switched off before installation, uninstall or cleaning.
3. Use the enclosed protective gloves when handling the reflector, if applicable.
4. Ensure there is enough space for heat dissipation of the luminaire, do not place anything in 10cm around the luminaire. The luminaire must not
under any circumstance be covered with heat insulating materials.
5. The luminaire must not be installed on inflammable parts of building.
6. Keep object out of the required minimum distance along the optical axis of the light source.
7. Please refer to the specific installation instructions, the label or imprint on the luminaire for information concerning any restrictions relating to
the use of luminaire, type of installation and etc.
8. If necessary the ceiling should be reinforced at the supporting points of the mounting frame or bracket.
9. The luminaire must only be operated with control gear matching the LED module provided or recommended by AKZU. No liability is accepted if
used with other control gears.
10. When installing, always observe relative local rules and regulations.
Limitations
Our warranty is contingent upon the observance of this product information, in particular, it shall be void if the fitting instructions are not followed,
the fitting dimensions are not observed, or any modification is made to the luminaire.
Cleaning
1. Luminaires should be cleaned regularly to make sure its working in good condition.
2. Disconnect the power and wait it is cooled down before cleaning.
3. Use soft cloths to clean.
4. Use litmusless detergent.
5. Do not use rigid, sharp, frictional or similar material or tool to clean
6. Do not use acidic, alkaline, ethanol or similar chemicals to clean.
01
All data, images,
and specifications
are for reference only and
may be changed due to
product improvement
without prior notice.
www.akzu.com

8-12mm
02
All data, images,
and specifications
are for reference only and
may be changed due to
product improvement
without prior notice.
www.akzu.com
F
min.120mm min.70mm
64mm
103mm
28mm
13mm
64mm
103mm
28mm
8mm
13mm
Magnetically attractable material
Nonmagnetic material
Nonmagnetic material
Magnetically
attractable material
360°
90°
360°
90°

03
All data, images,
and specifications
are for reference only and
may be changed due to
product improvement
without prior notice.
www.akzu.com
1
2
Power in
Power out
in
out
out
out
out
out
out
out
Power in
Power out
in
out
out
out
out
out
out
out
S
For Sprite X3 standard
Do not unplug the short circuit terminal of the unused port, otherwise the current can not
form a loop and the light can not be turned on.
min
Dimmer
Honeycomb anti-glare
X3 Change the Angle

04
All data, images,
and specifications
are for reference only and
may be changed due to
product improvement
without prior notice.
www.akzu.com
on
off
1
2

All data, images,
and specifications
are for reference only and
may be changed due to
product improvement
without prior notice.
www.akzu.com
05
Connect dimmer(1-10V)/DALI
220-240VAC
Constant Current/Voltage Driver
One to Two Splitter
Extension Cable
1m/2M/3M
Extension Cable
1m/2M/3M
Connect dimmer(1-10V)/DALI
Constant Current/Voltage Driver
220-240VAC
Multi-Access
Parallel /Series
Connector
Multi-Access
Parallel /Series
Connector