Ambient Weather EZ2-35W2MC User manual

Page 1
Ambient Weather
6845 W. Frye Road
Chandler, AZ 85226
TEL [phone] FAX [phone]
www.AmbientWeather.com
EZ2-35W2MC Pole Mounting Kit
Ambient Weather pole mounting kit constructed of
rust proof 10-steel tubing, galvonized using the Flo-
Coat (zinc-chromate ploymer) for excellent
corrosion proof protection.
Includes one 35" 1.25"-diameter smooth mast and
one 1.25"-diamter 35" swaged mast for an effective
height of 68".
Includes two 1.25" clamps, and four –¼" diameter
x 3" lag screws for mounting to any vertical surface.
Anemometer pictured is not included.
Figure 1
Components
The EZ2-35W2MC Mounting Pole kit assembly includes the following components.
Figure 2
Tools and Materials Needed
Adjustable Wrench
Level or Plumb
Drill

Page 2
Ambient Weather
6845 W. Frye Road
Chandler, AZ 85226
TEL [phone] FAX [phone]
www.AmbientWeather.com
Important Installation Instructions
CAUTION: Any metal object may attract a
lightning strike, including your weather station
and tripod.
Never install your weather station in a
thunderstorm.
We recommend properly grounding the tripod to
avoid extensive damage to the weather station
and structure. Consult a licensed electrician or
local lightning detection expert prior to installing
a ground wire.
Mounting Pole Installation
1. In a fence post or other flat vertical
surface, drill two holes, using one of the
1-1/8” saddles as a guide.
2. Drill another set of holes at least 12”
away from the first holes.
3. Using the lag screws, secure the saddles
and into the post.
4. Tighten the lag screws until the tube
will not slide up or down.
5. Insert the swaged end of the support
tube in the open top of the extension
tube.