Trojan 459390 User manual

USER
MANUAL
8U/12U/16U Wheeled
Racks

Trojan Equipment Racks
The Trojan series of Equipment Racks come in three sizes
8U code 459390 12U code 459400 16U code 459410
Assembly Instructions
Contents 10 packages for assembly
1. Caged Nuts
2. L Brackets for supporting equipment
3.16 Plastic Bungs to conceal holes
4. Hexagonal M6x15 securing screws
for front panel
5. 16 Large Hexagonal screws for
fixing side panels to top and base
6. Plastic Cup washers for hexagonal
equipment mounting screws
7. Hexagonal Allen Key large
8. Hexagonal Allen Key small
9. GP2Y small spanner
10.M6x10 hexagonal round screws
Base assembly
Locate the largest panel, the Base.
Decide which of the long edges you want to be at the front. Screw in the
four casters using the spanner provided. Two casters are locking and
should be along the front edge of the base. Non locking casters are then
at the rear.
Side to Base Panel mounting
Lay one of the side panels with it’s outside edge on a table with the bottom
edge just protruding over the table edge.
Side panels have no predetermined front
or back or top or bottom.
Locate the 16 large M8x15 Allen Key
screws which hold the side panels to the
base plate and top plate, also the large
Allen Key.
Racks Manual:Layout 1 14/10/2016 11:16 Page 1

Secure the side panel to the base using 4 screws.
Repeat for the other side panel. Push 8 plastic bungs into the holes to
conceal the bolts. Stand the rack upright on its castors with no top panel
fitted.
L Bracket Assembly
Locate and assemble all the L brackets with a caged nut using the pack of
the SHORTER M6 x 10 hexagonal headed screws as shown.
Initially, do not fully tighten the screw in the caged nut.
These L brackets are used to support the middle/rear of the
equipment when mounted in the rack.
However they may not be required if the equipment is lightweight.
L Bracket positioning
Slide half the supplied L bracket assemblies down the U
shaped channel which is welded from top to bottom on
either side of the cabinet. As the L brackets may not be
required let them fall to the bottom of the U Channel.
Either tighten the screw so the brackets do not move
from their unused position at the bottom of the U
channel or slide them up into position to support the equipment.
Final assembly
Fit the top panel using the remaining 8 large bolts and push in the plastic
bungs to conceal the holes.
Equipment mounting
When mounting the equipment using the supplied bolts, ensure the
supplied plastic cup washers are used otherwise the face of the
equipment will be marked.
Racks Manual:Layout 1 14/10/2016 11:16 Page 2