AmerTac Westek BL-BUTN-W User manual

BL-BUTN-W Compact Bar Light Owner’s Manual
Battery Installation
1. To open, when looking at the back, slide the cover in the direction of the
“open” arrow and remove.
2. Insert 4 AA batteries (follow the illustration inside the battery compartment).
Ensure the batteries are inserted so that the flat ends are making contact
with the springs.
3. To close, replace the cover and slide in the direction of the “close” arrow.
(Please note the cover has different size prongs to fit in only one direction to
ensure the arrows point in the right direction.)
Operation
Tap the lens once for on, tap again to dim, and a third tap will turn off the light.
Light Installation
Determine mounting location and type of mount.

CAUTION: Be cautious of what surface the adhesive is attached, as it may
remove paint or damage surface.
Mounting with double-sided 3M adhesive tape
1. Locate the two tape pieces in your package. Peel and remove one side
of the tape backer to expose adhesive and firmly attach to the indented
squares on back of light bar.
2. Make sure the area where you want to attach the light is clean and clear of
debris and dust.
3. Peel and remove the other sides of tape backer and place the light bar in
the desired mounting location. Firmly press the adhesive tape against your
surface to mount the light.
Mounting with screws
1. Remove the back of light by sliding the cover in the direction of the
“open” arrow.
2. Use the two holes in the back as a guide to drill pilot holes.
3. Secure the back to your mounting surface with included
screws – do not overtighten.
Limited Warranty
Under normal use and conditions, AmerTac provides to the original purchaser of this
product a one year limited express warranty that is set forth in the Limited Warranty
stated in full at www.amertac.com/warranties. The Limited Warranty is in lieu of all other
express or implied warranties or liabilities subject to the exceptions explained fully in the
Limited Warranty on the website.
©2021 AmerTac™
250 Boulder Dr.
Breinigsville, PA 18031
610-336-1330
www.amertac.com
Made in China
BO_TL_049_0321