1161 Ringwood Ct, #110, San Jose, CA 95131, U. S. A. Tel.: (408) 748-9100, Fax: (408) 770-9187 www.analogtechnologies.com
Copyrights 2000-2021, Analog Technologies, Inc. All Rights Reserved. Updated on 3/18/2021 Email: staff@analogti.com/sale[email protected] 4 High Temperature Alarm
If the measured temperature > F7, an alarm will be
triggered. The screen will display H and the current
temperature alternately. Press any button to stop the alarm
sound.
High Temperature Alarm Setting
Press the Rst to enter the menu, and then press ▲or ▼
until "F7" is displayed. Press Rst to display the high
temperature alarm pre-set value, and then press the ▲or
▼ to adjust the value.
Low Temperature Alarm
If the measured temperature < F6, the screen will display L
and the current temperature alternately. Press any button to
stop the alarm sound.
Low Temperature Alarm Setting
Press the Rst to enter the menu display, and then press ▲
or ▼until "F6" is displayed. Press Rst to display the low
temperature alarm pre-set value, and then press the ▲or
▼ to adjust the value.
NOTE
Fault Tips
1. When the sensor is disconnected, the screen shows ---,
and the alarm sounds, shut down the TEC module and fan.
2. When the sensor detects a temperature < −9.9°C , the
display shows LLL.
3. When the sensor detects a temperature > 99.9°C , the
display shows HHH.
Precautions
1. The load shall not exceed the output contact capacity,
otherwise it may bring damages to the cooler and cause fire.
2. The connecting wires and wiring terminal shall in good
connection, otherwise, it will reduce the reliability of the
cooler.
3. When wiring, separate the power supply, relay, and
sensor, otherwise it will damage the cooler.
ORDERING INFORMATION
Table 2. Unit Price
NOTICE
1. ATI warrants performance of its products for one year to the specifications applicable at the time of sale, except for those
being damaged by excessive abuse. Products found not meeting the specifications within one year from the date of sale can
be exchanged free of charge.
2. ATI reserves the right to make changes to its products or to discontinue any product or service without notice, and advise
customers to obtain the latest version of relevant information to verify, before placing orders, that information being relied
on is current and complete.
3. All products are sold subject to the terms and conditions of sale supplied at the time of order acknowledgment, including
those pertaining to warranty, patent infringement, and limitation of liability. Testing and other quality control techniques are
utilized to the extent ATI deems necessary to support this warranty. Specific testing of all parameters of each device is not
necessarily performed, except those mandated by government requirements.
4. Customers are responsible for their applications using ATI components. In order to minimize risks associated with the
customers’ applications, adequate design and operating safeguards must be provided by the customers to minimize inherent
or procedural hazards. ATI assumes no liability for applications assistance or customer product design.
5. ATI does not warrant or represent that any license, either express or implied, is granted under any patent right, copyright,
mask work right, or other intellectual property right of ATI covering or relating to any combination, machine, or process in
which such products or services might be or are used. ATI’s publication of information regarding any third party’s products
or services does not constitute ATI’s approval, warranty or endorsement thereof.
6. IP (Intellectual Property) Ownership: ATI retains the ownership of full rights for special technologies and/or techniques
embedded in its products, the designs for mechanics, optics, plus all modifications, improvements, and inventions made by
ATI for its products and/or projects.
