AniFusion IV User manual

IV PUMP
QUICK START GUIDE
We have written this quick start guide for use with the mls/hr mode, in order to allow the user to
deliver an infusion as quickly as possible.
You must use electrical power for its rst use and allow the battery to fully charge before
using battery power.
You can only use a pre set Aniset™ line: to use a different line that is not calibrated for use will
lead to inacurate uid delivery.
1 Plug the Anifusion®IV Pump into an electrical supply.
2 Press and hold the power button located at the bottom left hand corner of the pump.
3 On Main menu, select modes.
4 Select ml / hr mode
Select VTBI (volume to be infused) and
using keypad, enter the amount of uid
required.
Press when complete.
5 Select Rate
Using the keyboard enter the mls/ hr rate
you wish to use
Press when complete.
Power Button Modes

Time will adjust itself based on amount of uid and infusion rate
you have entered.
6 Select volume
The Anifusion®IV Pump will ask if you wish to reset total volume.
Press
7 (Pump calibrated tubing) Open the door to the infusion pump
and insert the primed line running from top to bottom.
Close the door ensuring it clicks shut.
8 The Anifusion®IV Pump will ask you to select which line you
would like to use and will show you your options.
Conrm your selection
9 Press the start / stop button located on bottom right hand side
of the pump to start the infusion.
Start/Stop
Button
millpledge.com
United Kingdom: 08000 11 22 88 — [email protected]
USA: [phone] — [email protected]
Canada: [phone] — [email protected]
Europe: [phone] — [email protected]
Australia: local: 1800 950 585
international: [phone] — [email protected]