Anonimo MILITARE CHRONO User manual

USER GUIDE MILITARE CHRONO

MILITARE CHRONO
REF. AM1120
Water-resistant crown with locking protective lever
Water-resistant start/stop button
Water-resistant reset push button
Continuous second hand treated with luminous coating
30 minutes chronograph counter hand treated with luminous coating
Hour hand treated with luminous coating
Minute hand treated with luminous coating
Second chrono
Position 0: The watch is working and water
resistance is guaranteed. The crown is locked
thanks to the patented protective lever.
Position 1: Set the date
SETTING THE TIME
1. Unlock the protective lever: rotate the protective lever up, and then lower the vanishing
crown device. Get over the resistance of the click due to the lock catch.
WARNING: In this position water resistance is not guaranteed and the crown is not pro-
tected. It is still possible to set the time, date and wind the movement.
Repeatedly opening and closing the lever can aect the mechanism, do so only when
necessary to set the time
2. Setting the time: once the lever is unlocked, pull out the crown completely to the
second click. Rotate the crown clockwise to set the time. In this position water resistance
is not guaranteed. After setting the time, return the crown rmly to its initial position and
lock the protective lever. To fully lock, the protective lever must be placed in the low posi-
tion (Pos.1).
In this position the watch is water-resistant to its rated depth.
Patented Crown Vanishing Locking Device
WARNING: The lever is designed to block the crown when the watch is worn.
If the strap is not fastened around the wrist, security of the crown is not ensured.
H
F
G
A
D
E
C
B
A
B
C
D
E
F
G
H
-
-
-
-
-
-
-
-
1
0
Pos.1 Pos.2
Locked Position Unlocked Position

WINDING THE WATCH
Unlock the protective lever as explained in the «setting the time» section.
Pull the crown to the rst click and turn crown clockwise 15-20 rotations to fully wind the
movement.
When the watch has been rewound, the power reserve indicator hand will raise and reach
the non-red area.
Note: When the watch has not been worn or wounded for more than 35 hours, it is
recommended that it should be rewound with a few clockwise turns on the crown, to
ensure sucient power reserve and accurate operation. In this position water resistance
is not guaranteed.
OPERATING CHRONOGRAPH
Starting and stopping the chronograph:
Push on button B to start the chronograph. Once started, the chronograph will track
elapsed seconds (D)
and minutes (E). Pressing the push button B a second time will stop the chronograph.
Pressint it again will restart the chronograph from the intermediate stop.
Resetting the chronograph:
To reset the chronograph, it must rst be stopped, using push button B.
Once stopped, pressing the second push button C will reset the chronograph
mechanism to zero.
IMPORTANT: You should always press the push buttons following the below sequence,
otherwise you may damage your watch’s movement.
B: Start / B: Stop / C: Reset
SPECIFICATIONS
Movement:
Anonimo CAL. 110013, Automatic Sellita caliber SW300-1 11 1/2, 47 jewels, 28’800
A/h, stop-seconds, power reserve 42 hours.
Dubois-Dépraz 2035M chronograph module modied upon specications of Anonimo.
Water Resistance:
12 ATM
-
-
1.
2.
3.