Aquatec AQUAPRO 12 LED RING LIGHT User manual

INSTRUCTIONS MANUAL
LED POND LIGHT
IMPORTANT SAFEGUARDS
To guard against injury, basic safety
precautions should be observed including
but not limited to the following;
The transformer is under no•
circumstances intended to be placed
in the pond or water feature, it must
therefore be located within three
meters of the pond or water feature in
a suitably dry and protected position.
It should be out of direct sunlight and
preferably mounted at least 30cm
above ground level.
Do not operate the light if the light or•
any of its components of the light such
as the cord have been damaged in
any way.
Always use a properly grounded•
power supply that is connected to an
RCD of less that 30mA. As per AS/
NZS 3350.2.41:1997.
Always unplug the light from the power•
supply when not in use or before
performing any maintenance on the
light. Never pull the cord to disconnect
the plug from the power supply. Grasp
the plug and pull to disconnect.
Do not cut the cord as this will result in•
voiding your warranty.
Care should be taken to arrange•
the power cord so that it cannot be
accidently tripped over or pulled.
Do not attempt to repair the light•
yourself. Return to an authorized
service centre or place of purchase if a
fault occurs.
Do not use in water above 35°C.•
Do not attempt to use this transformer on•
any other device without first verifying
with Aquatec
LIMITED WARRANTY
Warranty covers only appliance•
defects and faulty material and
workmanship within a 2 year period.
Faults arising due to; accidents,•
misuse, not following manufacturer’s
guidelines/ instructions or power
surges/spikes/brownouts will not be
covered.
Warranty will be void if any•
tampering removal of warranty labels
or electrical is evident.
Loss of livestock, damage to property•
or personal injury caused by this
product will not be covered
Warranty will be void if power cord•
is cut or damaged in any way.
Warranty claims caused by•
installation faults will not be covered.
It is the customer’s responsibility to•
return the faulty appliance for any
warranty claim, to Aquatec.
For any warranty to be valid, an•
original proof of purchase must be
provided.
Manufactured for:
AQUATEC EQUIPMENT
PO Box 648, Maddington, Western Australia, 6989
Telephone [phone]
Email [email protected]
www.aquatecequipment.com

Congratulations on your purchase of this
great addition to your pond or water
feature. Please check the list of parts to
see that you have everything that should
come in the kit.
DESCRIPTION AND FEATURES
Your Aquapro LED pond light has been
manufactured with advanced technology
to provide you with the best quality
lighting accessory for your pond.
The Aquapro LED light is suitable for•
use in or out of water.
The transformer converts the power•
supply to a safe 12volt for peace of
mind in your garden.
Dual hosetail to adapt to 12mm or•
19mm tubing.
INSTALLATION
If required, have a qualified•
electrician install a weather proof
power point near to the pond, (within
10 meters so the light cable will
reach the transformer.
Mount the transformer in a dry and•
protected location making sure that
it can’t be wet by either rain or
reticulation.
Connect desired hosetail to the LED•
ring by pushing on to base of LED
ring, connect tubing to hosetail and
position in desired location.
Connect cable to transformer taking•
care it does not get wet.
Connect power cable to a•
powerpoint and turn on the power to
the transformer.
MAINTENANCE
There is minimal maintenance requires on
the LED pond lights, the light should be
inspected on a regular basis to ensure the
light or cable is not damaged in any way.
The light should be cleaned regularly to
ensure maximum efficiency.
12 LED RING LIGHT (ALL COLOURS)
VOLTAGE (V) 12V
POWER (WATTS) 2.5W
CABLE LENGTH (M) 10M
DIMENSIONS (MM) 33MM DIAMETER (O/D)
LED POND LIGHT
1. Power Cable & Plug
2. 12mm Hosetail
3. LED Ring
(with 19mm Hosetail)
4.12V Transformer
5. 10M LV Cable & Plug
1 2 3 4 5