ARISIT ONE PPMM2-AL User manual

6
7
6
5
Cable management
Adjustable instruction
fall down
+
-
pop up
If you feel the pitching angle too tight or too loose
when adjusting the mount, please adjust the Screw
Turn clockwise to tighten
Turn counterclockwise to loose
+
-
Adjust flexiblity
180°
360°
+90°
-45°
360°
360°
PPMM2-AL 75x75/100x100 30 9kg
(19.8lbs)
4
Press the arm to make it keep it in horizontal position and then use the Allen Key to adjust the screw on the arm.
Turn counter-clockwise(”+ ” direction) to increase gas spring tension till can hold the weight of your monitor.
Note: You may need to turn the screw by many times to tighten the arm.
Case 1：Monitor/Arm fall down (after install your monitor)
Press the arm to make it keep it in horizontal position and then use the Allen Key to adjust the screw on the arm.
Turn clockwise(”- ” direction) to reduce gas spring tension till can stay the position needed.
Note: You may need to turn the screw by many times to tighten the arm.
Case 2：Monitor/Arm pops up (after install your monitor)
E
E
E
Aluminium
Monitor Arm
Made in China
Arisit Pty Limited Australia,
40-50 Mark Anthony Drive, Dandenong South,
VIC 3175 Australia Tel: [phone]
Arisit Pty Limited NZ,
1a Howe Street, Newton, Auckland,
1145 NZ, Tel: [phone]

1a-1
Method 1 Method 2 (desktop has a hole for item 2 go through)
1a-2 1b-1
2
3
M4x10 (x8)
A
1 (x1) 2 (x1) 3 (x1) 4 (x1)
4
8
E
E
30-80mm
10-50mm
10-30mm
1
5
5 (x1) 6 (x2)
Start by screwing the panel to the correct angle for easy placement of the monitor
Use a spanner（E）to screw the screws （A/B）and washers （C）into the two holes on the upper back
of the display, and then screw the VESA plate into the two holes on the lower end. Avoid excessive
tightening screws damage the monitor.
7 (x2) 8 (x1)
M5x10 (x8)
B
C (x8) 4mm (x1)
D
5mm (x1)
E
Connect with monitor
2
3
E
E
3
5
C
C
E
E
A/B
A/B
1
D
D