Arlec AEC001 User manual

Due to continuous research and development the specifications herein are subject to change without notice.
11 Litre Portable Air Conditioner
Instructions Manual AEC001
Important! Please read these instructions carefully.
AEC001 Instructions.indd 1 31/7/09 3:57:38 PM

2
3
SAFETY INSTRUCTIONS
• Keep the ice packs (supplied) away from the
children as they contain chemical based
crystals.
• DO NOT use this unit for functions other than
those described in this instruction manual
• DO NOT tilt the unit. Always keep in upright.
Position on a at and stable surface, where
it cannot be easily knocked over. Take extra
care when operating
• DO NOT cover or obstruct the air lter inlet or
outlet grilles
• DO NOT use the unit in a wet room, such as a
bathroom or laundry
• DO NOT sit or place articles on the unit
• DO NOT touch the unit with wet hands or bare
feet
• DO NOT let chemical substances come into
contact with the unit
• DO NOT use the unit in the presence of
inammable substances or vapour such as
alcohol, insecticides, petrol etc.
• DO NOT use the mains plug to start and stop
the unit
• DO NOT pull the supply cord or place it near
a heat source. Always unwind the cord
completely to avoid overheating. If the supply
cord is damaged it must be replaced by the
service agent or a similarly qualied person,
in order to avoid a hazard
• DO NOT allow children to play with this
appliance. This appliance is not intended
for use by children or inrm persons without
supervision.
• DO NOT conduct repairs on this unit. It has
been built in accordance with relevant safety
and performance standards. An electrical
specialist must carry out all repairs.
• If the power cord is damaged, it must be
replaced by a qualied electrician
• DO NOT use the unit without the lter tted
• DO NOT allow objects to enter any ventilation
or exhaust other than ice or water as
specied in these instructions
• This unit is intended for indoor use only.
• ALWAYS unplug the unit from the mains before
maintenance or cleaning
• ALWAYS use the switch on the control panel to
start and stop the unit
• ALWAYS keep a clearance of at least 20cm
from walls furniture and curtains
• ALWAYS turn off and unplug the unit when not
in use
• ALWAYS switch off, and unplug the unit before
lling up with water or ice
• Adequate clean water should be put into
the water tank within the water level limits
shown on the level indicator.
• Should you wish to move the unit any great
distance, or before storing it, always drain the
water from the tank using the plug provided at
the bottom of the unit.
• When draining the water tank always do this
over a bucket, outside so that water does not
damage the carpet or ooring
ENERGY SAVING TIPS
• Use the unit in the recommended room size of
up to 20m2 (assuming standard 2.4m ceiling
height)
• Do not locate the air conditioner where
furniture or other objects can obstruct the air
ow.
• Keep blinds/curtains closed during the
sunniest part of the day
• Close the replace damper, oor and/or wall
registers, so cool air does not escape through
the chimney or duct work
• Keep the air lter clean
• Set the unit to maximum cooling and high
speed ventilation for the initial startup, then
adjust the unit down to a more comfortable
setting as required
AEC001 Instructions.indd 2 31/7/09 3:57:38 PM

2
3
AIR CONDITIONER
1. Control panel
2. Air inlet filter
3. Cool air outlet
4. Horizontal louvers
5. Vertical louvers
6. Front body
7. Water level indicator
8. Water entrance
9. Caster wheels
10. Carry handle
11. Chiller bottles
12. Remote control
CONTROL PANEL
1. Power On/Off switch
2. Power indicator
3. Fan Speed Switch
4. Fan speed indicators :–
high, medium, low
5. Mode Switch
6. Mode indicators :–
Normal, Breeze, Circulate
7. Cool switch
8. Cool indicator
9. Oscillate switch
10. Oscillate indicator
11. Timer switch
12. Time indicators – 0.5 Hr, 1 Hr, 2 Hr, 4 Hr
13. Remote sensor window
IDENTIFICATION
1. Control panel
Air inlet filter 2.
3. Cool air outlet
4. Horizontal louvers
5. Vertical louvers
6. Front body
7. Water level indicator
Water entrance 8.
9. Caster wheels
12. Remote control
11. Chiller bottle
Carry handle 10.
1.
2.
5.
11.
3.
7.
4.
8.
10.
9.
6.
12.
13.
AEC001 Instructions.indd 3 31/7/09 3:57:38 PM

4
5
OPERATION
Turning ON/OFF
Press the power On/Off button to turn
on or turn off the evaporative cooler.
Setting Fan SPEED
Press the speed button to set fan
speed. Press the button repeatedly to
change the fan speed – Low, Medium
and High
Setting the Mode
Change the mode to the desired type
(Normal, Breeze and Circulate) by
pressing the mode switch repeatedly.
Modes Explained
Normal mode – The fan speed remains
constant at set speed (Low or Medium
or High). This mode is recommended
normal operation.
Breeze mode – The fan speed varies
randomly (Low, Medium, High and off)
giving the effect of natural breeze. It is
recommended to set the fan speed at
high under this mode for better result.
Circulate (sleep) mode – The fan
speed switches on and off at set
speeds thus saving energy during
night. It is recommended to set the
fan speed at low under this mode for
quieter performance and less energy
consumption.
* Please make sure sufcient
water is in the storage tank before
operation.
Refer to Storage & Drainage section for
details.
Cool Function
Cool switch is used to operate the
automated water conveyor system.
This function is recommended for
higher/efficient cooling effect under
any mode.
Oscillate Function
(Regulating air flow direction)
Oscillate function switch is used to
direct the air flow automatically from
horizontally (side to side) by means of
the vertical louvers. This can be done
while the unit is in operation.
To control the air flow direction via
the horizontal louvers adjust louvers
manually (louvers interlocked).
Setting Timer
Set the Timer to the desired operating
time (0.5 Hour to 4 Hours) by pressing
the Timer switch repeatedly. When the
set time has been reached the unit will
shut off automatically.
AEC001 Instructions.indd 4 31/7/09 3:57:39 PM

4
5
Remote Control
• Thisremotecontrolrequires2XAG13
(LR44) alkaline 1.5V batteries.
• Toinstallthebatteries,remove
the battery cover then insert the
batteries in right polarities (+/-).
Replace the battery cover before
use.
• Theremotecontrolhasallthesame
functions as the buttons on the
control panel of the air cooler.
• Tousetheremotecontrol,make
sure that the air cooler unit is
plugged into the mains supply, then
point the remote at the sensor on
the top of the main unit, and press
the desired button.
• Theremotecontroloperatingrange
is 7 meters. It is ideal not to have
any obstacles between the remote
and the sensor.
STORAGE AND DRAINAGE
Sufficient water needs to be stored in
the storage tank (at the bottom of the
unit) to ensure supply of cool air.
Before storing water in the unit, switch
the unit off and unplug from the
mains supply. Water is poured into
the storage tank through the water
entrance on the side of the unit as
shown below to appropriate level
(from the water level indicator in the
front of the unit).
Make sure that the water storage tank
is re-filled once it runs out.
To drain the water when the unit is not
in use.
1. Position a water tray flat on the floor,
beneath the drain hole.
2. Unscrew the drain cap at the bottom
of the unit and then remove the
water plug from the drain hole,
allowing the water to drain out.
(refer to figure below)
3. When the drain tray is almost full
replace the water plug into the drain
hole and empty the tray.
1. Power ON/OFF
2. Fan Speed
3. Louver Oscillation ON/OFF
4. Timer ON/OFF
5. Cool ON/OFF
1.
2.
3.
4.
5.
Drain cap location
AEC001 Instructions.indd 5 31/7/09 3:57:39 PM

6
7
Chiller Bottles
The chiller bottles provided with the
unit must be filled with water and must
be allowed to freeze in a refrigerating
unit (in an upright position) prior to
their use in the cooler unit.
The strings provided in the side water
entrance of the unit is secured to the
chiller bottle cap hook (as shown in
Fig 1.) before placing the bottle into the
cooler unit. Fig 2.
Cleaning and Maintenance
• Alwaysswitchoffandunplug
from the mains supply before
attempting any kind of cleaning and
maintenance.
• Afterextendedperiodofuse,replace
the water in the tank with fresh
water.
• Theairlter(only)attheinletatthe
rear of the unit can be cleaned if
required. The foam filter should be
cleaned in a mild soapy solution,
then left to dry before replacing.
• Externalenclosurecanbecleaned
with a damp cloth.
Cleaning the Air Filter
Unplug the power cord, loosen the
screw of the air filter to remove the air
filter. In a smoky or dusty environment
the filter may appear gray after 1-2
months and will need to be cleaned. In
conditions without smoke or minimal
dust, the filter to be cleaned every 1-6
months depending on the condition of
the filter.
Wash the air filter with warm soapy
water and a soft brush. Place side of
filter with the light contact agent facing
upwards in the sun for at least 4 hours
to re-generate the light contact agent
and re-fit it back in the unit.
Fig 1.
Fig 2.
AEC001 Instructions.indd 6 31/7/09 3:57:40 PM

6
7
SPECIFICATIONS.
Input power consumption:
65 watt
AEC001 Instructions.indd 7 31/7/09 3:57:40 PM

8
GUARANTEE*
Arlec guarantees this product against defects of
materials and workmanship for a period of 24 months
from the date of purchase provided that the product
is used in accordance with Arlec’s recommendations
and within such voltage and current limits as are
specified by Arlec in relation to the product. Arlec will
at its own option make good, replace with the same
or similar product, or provide credit for any product
manufactured or supplied by it, which proves to be
defective within the limits set out above provided
always that no repairs, alterations or modifications
to the product have been undertaken or attempted,
other than by the company or its authorised agents.
Should the purchaser wish to make a claim under the
guarantee, the product should be returned pre-paid
to the place of purchase. To obtain warranty the
purchase receipt must be returned with the product.
This guarantee is in addition to and does not take
away from any rights available to the consumer under
the Trade Practices Act and the State consumer
protection legislation.
* 24 month guarantee applies for domestic use only.
* Warranty excludes:
Damage or malfunction due to willful abuse or
misuse.
Proof of Purchase
Please retain your receipt for all service or warranty
claims
© This instruction leaflet is subject to copyright and must not
be reproduced, copied or otherwise used in any way or for any
purpose without the consent in writing of the owner,
Arlec Australia Pty Ltd (A.C.N. 009 322 105)
CPIN1080
For all Sales enquiries:
Phone [phone] Fax [phone]
AEC001 Instructions.indd 8 31/7/09 3:57:40 PM