Artek A910 User manual

LIGHT A910
BEFORE YOU START
Read these instructions carefully before commencing
installation. Do not attempt to fit installation unless
you are competent. If any doubt consult a qualified
electrician. The lighting is intended for use in a normal
dry indoor environment.

1.Remove the wall bracket by unfasten-
ing the screws. Be careful not to dam-
age the shade.
90mm
60mm
Mounting hole measuremets 2. Drill two ø6mm holes to the wall. The
distance between holes should be 90mm.
Make sure the holes are horisontal. Install
plastic blugs to the holes.
3. Istall wall bracket as shown below.
4. Attach the mounting cup to wall
bracket by fastening the screws
5. Attach the lightsource. Use max.
60W, E27.
Kiinnitysreikien mitoitus
NOTE: If the external flexible cable
or cord of this luminaire is damaged
it shall be exclusively replaced by the
manufacturer or his service agent or
similar qualified person.
5. Attach shade to monting cup by
fastening the screws.