Ashford RHLSV030820 User manual

Ashford Guarantee
Thank you for purchasing this Ashford product. In the unlikely event there is
any fault in manufacture please contact the Ashford Dealer who supplied it. To
validate our guarantee please visit our website -support - product registration,
or email us.
Ashford HandicraftsLimited
41 West Street, P O Box 474, Ashburton, New Zealand
[phone]
[e-mail]
www.ashford.co.nz
RIGID HEDDLE LOOM STAND VARIABLE WIDTH
For 40cm (16"), 60cm (24") or 80cm (32") Looms
RHLSV030820

3. Insert 4 mm (1¾”) bolts from the inside of your loom and
tap the head of the bolt flush against the loom side. Locate the
loom and bolts into the slots in the legs and secure with
washers and knobs.
4. Note the support braces are left
and right. Check they are on the
correct side and attach them to the
legs with mm (2¼”) bolts, spacer
blocks, washers and knobs.
5. Sit at the loom and adjust the angle of the loom and footrest
to suit. Raise the support braces up under the front cross rail
and tighten all knobs and bolts.
6. Store the Hex Key in the hole in the footrest so you can
retighten the bolts if required.
7. The Freedom Roller can be attached to back of the loom to
use when weaving thick rugs or for long warps.
Enjoy weaving comfortably on your Rigid heddle Loom!
0mm (2”) bolt
Foot
Barrel nut
Footrest
Rigid Heddle Loom 40cm (16”
Support brace(Right)
RightLeft
Support brace(Left)
Rigid Heddle Loom 60cm (24” and 80cm (32”
1. Secure the footrest to both extender rails using the
appropriate holes, with 32mm (1¼”) bolts and barrel nuts.
2. Attach this footrest assembly to one leg and one foot as
illustrated with 0mm (2”) bolts and barrel nuts and lightly
tighten with the Hex Key. Note the tapered leg fits snuggly into
the tapered rebate in the foot. Repeat for the other side.
For 80cm(32”) width looms
For 60cm(24”) width looms
4 mm (1 ¾”) bolt
mm (2 ¼”) bolt
Spacer block
Washer
Washer
Knob
Knob
0mm(2”) bolt
32mm (1 ¼”) bolt
Footrest
Extender rail Foot
Leg
Barrel nut
Barrel nut
Rigid Heddle Loom 40cm (16”
Attach the footrest to one leg and one foot as illustrated with a
0mm (2”) bolt and barrel nut and lightly tighten with the Hex
Key. Note the tapered leg fits snuggly into the tapered rebate in
the foot. Repeat for the other side. Store the 2 extender rails
and 32mm (1¼”) bolts and barrel nuts for future use with
either a 60cm (24”) or 80cm (32”) Rigid Heddle Loom. Proceed
to Step 3.
Loom side
Front rail
Support brace
Foot
Leg
Foot
Leg
Ashford HandicraftsLimited
41 West Street, P O Box 474, Ashburton, New Zealand
[phone]
[e-mail]
www.ashford.co.nz