Ashford KLSV030820 User manual

Ashford Guarantee
Thank you for purchasing this Ashford product. In the unlikely event there is
any fault in manufacture please contact the Ashford Dealer who supplied it. To
validate our guarantee please visit our website -support - product registration,
or email us.
Ashford Handicrafts Limited
415WestStreet,POBox474, Ashburton, New Zealand
[phone]
[e-mail]
www.ashford.co.nz
KLSV030820
For 30cm (12"), 50cm (20") or 70cm (28") Looms
KNITTERS LOOM STAND VARIABLE WIDTH

RightLeft
3. Loosen the side knobs on your knitters loom. Then locate
the loom and bolts into the slots in the metal brackets
keeping the washers between the bracket and the knob.
4. Note the support braces are left
and right. Check they are on the
correct side and then attach them
to the legs with 45mm (1 ¾”) bolts
washers and knobs.
5. Sit at the loom and adjust the
angle of the loom and footrest to
suit. Raise the support braces under the front cross rail and
tighten all knobs and bolts.
6. Store the Hex Key in the hole in the footrest so you can
retighten the bolts later if required.
Enjoy weaving on your Knitters Loom!
Knitters Loom 50cm (20”) or 70cm (28”)
1. secure the footrest to both extender rails using the
appropriate holes with 32mm (1 ¼”) bolts and barrel nuts.
2. Attach this footrest assembly to one leg and one foot as
illustrated with 50mm (2”) bolts and barrel nuts and lightly
tighten with the Hex Key. Note the tapered leg fits snuggly into
the tapered rebate in the foot. Repeat for the other side.
50mm (2”) bolt
Foot
Barrel nut
Footrest
Knitters Loom 30cm (12”)
Knitters Loom 30cm (12”)
Attach the footrest to one leg and one foot as illustrated with a
50mm (2”) bolt and barrel nut and lightly tighten with the Hex
Key. Note the tapered leg fits snuggly into the tapered rebate in
the foot. Repeat for the other side. Store the 2 extender rails
and 32mm (1 ¼”) bolts and barrel nuts for future use with
either a 50cm (20”) or 70cm (28”) Knitters Loom. Proceed to
Step 3.
Support brace(Right)
Support brace(Left)
Bolt (Loom parts)Bolt (Loom parts)
45mm (1 ¾”) bolt
32mm (1 ¼”) bolt
For 70cm (28”) width looms
For 50cm (20”) width looms
Washer (Loom parts)
50mm (2”) bolt
Barrel nut
Barrel nut
Washer
Knob
Side knob (Loom parts)
Footrest
Extender rail Foot
Leg
Loom side
Front rail
Support brace
Foot
Leg
Foot
Leg
Ashford Handicrafts Limited
415WestStreet,POBox474, Ashburton, New Zealand
[phone]
[e-mail]
www.ashford.co.nz