Atlantic 63607145 User manual

MIN:7.87 in / 200 mm
MAX:31.50 in / 800 mm
+50
_150
2.75 in / 70 mm
MAX:15.75 in / 400 mm
THIS INSTRUCTION BOOKLET CONTAINS
IMPORTANT SAFETY INFORMATION. PLEASE
READ AND KEEP FOR FUTURE REFERENCE.
Lot Number:
Date:
Product Warranty: The Manufacturer, warrants to the original purchaser that its products are free
defective in materials or workmanship, we shall repair or replace the product at our discretion.
This warranty does not cover accidental damage, misuse, improper care or alteration and
excludes claims for incidental or consequential loss. This limited warranty applies to product
Keep this Instruction Manual for future reference.
Keep your original proof of purchase (store receipt).
If parts are missing, DO NOT return to the store.
To order missing / replacement parts or for assembly assistance please
contact [email protected]
Or call 1-855-828-5679 M- T h, 8am-5pm, Fri, 8am-12pm, P.S.T.
also have other rights which vary from State to State. The warranty duration is one year.
Tilting Wall Mount
Fits 37" to 84" Flat Panel TVs
Model No: 63607145, 63607069

Become familiar with the instructions and all parts.
Make sure that all parts in the box and in good condition.
Do not install on a sloping surface.
Never let children climb on product or play with product.
Do not sit or stand on furniture.
Do not place a weight that is heavier than the recommended load rating on the product surface.
If you do not understand these instructions, or have doubts about the safety of this installation,
or injury caused by incorrect mounting, assembly or use.
The unit will hold a 37 to 84 in (94to 213 cm) Plasma or LCD TV. The weight of the TV must
TV plus the mount.
Improper handling can result in cuts and lacerations.
Images are for reference only.
Use electrostatic dust cloths to clean product surfaces.
1

2
Item Item
Components Components
A1
B1
C1
E4
Tools Needed (Not Included)
F
G
2
2
Parts List
Qty Qty
7/32 in. or 5.5 mm
Safety Hammer Wood Drill Bit Phillips Drill Stud Finder
Glasses Screwdriver
Note:
before assembly.
Wood Double Stud
Stud Finder
16in. /407mm
or
24in. /610mm

3
AE
F
Gsafety screws
B
C
2
1
This mount is designed to be attached into wood
studs. DO NOT use wall anchors. Using a stud
a pencil mark the hole locations at the desired
height, making sure you are level. Use the wall
plate (A) as a template to mark the two remaining
hole locations. Drill pilot holes at four pencil marks
2.5 in. (64 mm) deep, using a 7/32 in. or 5.5 mm
diameter drill bit.
Attach wall plate (A) to wall with four washers and
screws (E).
Attach TV mounts (B and C) to the TV back panel.
Make sure to select the same height screw holes,
so the mounts are centered and level.
Refer to the next page to select the correct
mounting hardware for your TV.
34
Turn two handles (F) into the mounts through
washers (G) but do tighten. After wall mounting
your TV, adjust TV to the desired viewing angle
and turn to tighten both handles.
We strongly recommend two people, one on
each side, hold the TV. Tilt the top of the TV
toward the wall. Carefully position TV mounts
(B and C) over the wall plate until both lock in
place. Tighten safety screws.
16in. /407mm
or
24in. /610mm

4
Mounting Hardware List Qty Mountin g Hardware List Qty
4
4
4
4
4
4
4
4
4
4
4
4
H
I
J
K
L
M
N
O
P
Q
R
S
TAKE EXTRA CARE AND PAY ATTENTION WHEN YOU FASTEN THE TWO TV MOUNTS TO THE BACK TV PANEL IN
STEP 2. MAKE SURE TO USE THE APPROPRIATE MOUNTING HARDWARE FOR YOUR TV.
1. Select the correct Mounting Hardware according to the screw hole size on your TV. Discard any
remaining screws and spacers.
2. Carefully lay your TV face down on a non-abrasive surface, laying padding underneath it to protect
the screen.
3. Place the right and left TV mounts in their appropriate positions, making sure they are CENTERED
on the back of the TV and LEVEL with one another.
M8 X 16
M6 X 12
M5 X 12
M4 X 12
M8 X 40
M6 X 35
M5 X 30
M4 X 30
M4 / M5 washer
M6 / M8 washer
M8 / M6 spacer
M4 / M5 spacer

HDMI Cable
Information:
This Kit includes 1 HDMI™ cable
Supports Ethernet and 3D
O.D.: 6.0mm
Single molding
1.4 Version
Each HDMI cable measures 6 feet (1828.8 mm) in length.
5
U.S. and other foreign patents pending /
Patentes de los EU A y países extranjeros en trámite /
Brevets en cours pour les États-Unis et autres pays /
U.S. und andere ausländische Patente sind hängig
All rights reserved / Derechos Reservados /
Tous droits réservés
Made in China / Hecho en China /
Fabriqué en Chine
www.atlantic-inc.com
R1.0 151106 #63607145
2015