Audio Pro BASIQ Sub User manual

1) Power LED:
Green light = ON
Red light = OFF or Standby
2) Mains switch
OFF / AUTO or ON
7) Volume control
8) Speaker level input
WARNING !
To reduce the risk of electric shock, do not open or remove cover or back. Do not expose this appliance to rain or moisture. In case
of malfunction consult qualified service personel.
The exclamation point, within an equilateral triangle, is intended to alert
theuserofthepresenceof importantoperatingandmaintenance(servicing)
instructions in the literature accompanying the appliance.
The lightning flash with arrowhead, within an equilateral
triangle, is intended to alert the user of the presence of
uninsulated "dangerous voltage" within the product´s
enclosure; that may be of sufficient magnitude to constitute a
risk of electric shock to persons.
3) Line input
4) Fuse
5) Mains cord (230V)
6) Lo-Passcrossover
(variable 50Hz - 150 Hz)
English
CONTROLS AND INDICATORS
6
TO REDUCE THE RISK OF FIRE,
REPLACE WITH ONLY THE SAME
TYPE AND RATING FUSE.
CAUTION
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK,
DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
DOUBLE INSULATION-
When serv c ng use only dent cal parts
BEFORE OPENING
PULL MAIN PLUG
VORSICHT
VOR DEM OFFNEN
NETZSTECKER ZIEHEN
LR
FROM RECEIVER
POWER
ON
AUTO
OFF
INPUT
CROSSOVER LEVEL
50 150 MIN MAX
Hz
FUSE TYPE:
T 800 mAL
230V~/50Hz
50 WATTS
CAUTION
CAUTION:
WARNING:
BASIQ SUB
Powered Subwoofer
Audio Pro AB. Sweden
1)
2)
3)
4)
5)
( 6
( 7
( 8

English
2.2 To Speaker or (Subwoofer speaker) terminal
(High level)
Connect speaker wires from the speaker terminals of your amplifier/receiver to the Speaker Level input on the
subwooferamplifier. Carefully check thepolarityofthewires (+ to+and-to -). ConnectbothLeftandRight channels.
The satellite speakers are connected to the main amplifier as usual.
INSTRUCTIONS
Congratulations to your choise of Audio Pro subwoofer and to a new sound experience.
Audio Pro subwoofer is a unique product built with advanced technique. It is very easy to
handleand install.It isequipped with abuilt-in amplifier anda longthrow woofer.Togetherwith
theextremely solid cabinet , the subwooferoffersanatural and deep bass reproductionatsound
levelsyouneverthoughtexisted.
The Audio Pro subwoofer offers extraordinary performance and lots of possibilities. In order
to get the most out of your new subwoofer, we recommend you to spend time and carefully read
these instructions before you connect and start up your system.
2. INSTALLATION
Therearedifferent methodstoconnect your subwoofer toaHiFi / Home Theater system.In the following weexplain
2 different ways. NOTE! Do not connect the mains cord until all other installation is completed.
2.1 To an amplifier / pre-amplifier with Subwoofer-out terminal.
Connectthe enclosed wirefromyour amplifierssubwoofer-outterminal toLINEIN onthesubwoofer.
Theaudio signalis passing throughthe cord from the subwoofer-out terminal to thebuilt-in amplifier.
Byusing theLO-PASS control,the upper frequnency of thesubwoofer canbe variablyselected from
50Hz- 150Hz.
Note: Connect the satellite speakers to the main amplifier speaker terminals.
1. UNPACKING
Carefully unpack the Audio Pro subwoofer and check for any damages. If possible, keep the cartonbox if future
transportation is needed.
You should immediately contact your dealer if the subwoofer is damaged .
7

8
English
3. FUNCTIONS
Power switch (2):
To switch thesubwoofer amplifierto ON,AUTO or OFF
mode.
Make sure that the power cord is not connected to
the outlet during installation.
AUTO MODE: The amplifiergoesautomatically into
standby mode if no signal been detected in 15 - 20
minutes. It goes on automatically if signal is detected.
ON MODE: Theamplifier will be constantly ON.
OFF MODE: Theamplifier isoff butnot totallyoff.
Diconnect the power cord from the outlet if it will not be
usedfor a period of time.
Main Power indicator: (1)
Green light indicates the subwoofer is ON.
Red light indicates that the subwoofer is either in
Standby or OFF mode. The red indication will be lit off
whenthe powercord is disconnected.
Volume control (7):
Thesound level ofthe subwoofer canbe adjusted. Use
theLevel control carefully,rememberthat
program material may contain very high energy.
LowPass (6):
The Lowpass crossover frequency can be adjusted
variablybetween 50 and150Hz.This givesyoua
unique possibility to perfectly match the Subwoofer to
yoursatellite speakersand to your preference.
TO REDUCE THE RISK OF FIRE,
REPLACE WITH ONLY THE SAME
TYPE AND RATING FUSE.
CAUTION
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK,
DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
DOUBLE INSULATION-
When serv c ng use only dent cal parts
BEFORE OPENING
PULL MAIN PLUG
VORSICHT
VOR DEM OFFNEN
NETZSTECKER ZIEHEN
LR
FROM RECEIVER
POWER
ON
AUTO
OFF
INPUT
CROSSOVER LEVEL
50 150 MIN MAX
Hz
FUSE TYPE:
T 800 mAL
230V~/50Hz
50 WATTS
CAUTION
CAUTION:
WARNING:
BASIQ SUB
Powered Subwoofer
Audio Pro AB. Sweden
1)
2)
3)
4)
5)
( 6
( 7
( 8

4. PLACEMENT 5.
TROUBLESHOOTING
If you should face any problem with the sub-
wooferfunction,pleasecheckthebelowpoint.If
the problem remains after checking, please
contactyour dealer.
1. Check that all connections have been made
properly. Check if any of the wires or connectors
aredamagedor short-cirquit.
Your Audio Pro subwoofer is designed to
produce music information in the frequency
range below 150 Hz. The human ear is being
devoided the ability to localize sound of these
lowfrequencies why the placement of thesub-
woofer is not critical. Audio Pro subwoofers
steep lowpass filters make the placement
easier to fit into your listening room. However
you can use the nature of the acoustic laws in
the following ways:
1. To get the most amplification of the room itself,
place the subwoofer close to a corner at a
distance of about 10 cm from the walls. If you
get to much bass, move the subwoofer slightly
out from the corner or adjust the level.
2. By experimenting with the placement of the
subwoofer, you can optimize the sound quality.
One good rule is to place the subwoofer at the
same wall as the satellite speakers.
3. Never cover the subwoofer or place it where the
built-in amplifier will be covered.
6. TECHNICAL SPECIFICATIONS
Amplifier(RMS):.....................................100Watt
Woofer:.................................................................8"
Frequencyrange:...................................29-200Hz
Lowpassfilter:.......................................50-150Hz
Dimensions: (W)..................................320mm
(H)...................................320mm
(D)...................................320mm
Weight:(net):.................................................9,0Kg
Specifications may be changed without notice, Audio Pro
follows a policy of continous advancement in development
English
9