Auto-Pyjama PermaBag User manual

PermaBag
®
For outdoor use
PermaBag® for outdoor use complete with:
• Auto-Storm® Top Cover for extra padding
• Silver Cover for outdoor weather protection
• PermaPack® moisture absorbing c linders
• Digital Thermo-H grometer
• Set of Storm-Straps
• Brass lock for PermaBag
D i r e c t i o n s
1. Choose a dr da with low humidit . A sunn dr da will accelerate the dr ing procedure.
2. Check that engine and exhaust are cool.
3. Check that car mats are dr and no perishable food is inside the car.
4. Check all rubber hoses and connectors, giving special attention to fuel lines, fuel tank and water
hoses such as the cooling s stem, wiper s stem, fuel s stem.
5. Remove tools and all private belongings.
. To prevent odours a packet of Bicarbonate of Soda ma be placed inside the car.
Do not use mothballs or an other toxic products.
7. Open side windows and retract or remove antennas.
8. Choose a suitable location, if possible protected from wind, storm and sun. The ground should be
non-porous and firm such as asphalt, gravel or cement. Do not park on earth, grass or sand!
9. Make sure the ground is free from all t pes of sharp objects prior to proceeding. Installation:
10. La the 3 Storm Straps on to the ground where the car is to be parked (see Picture 1 on reverse side)
11. La the PermaBag (zip still closed) on top of the three straps. All 6 ends of the 3 straps should be
visible. Unzip PermaBag and unfold. The three straps should be located underneath the section
with the ellow patch. The ellow patch should now be visible at the front left-hand corner.
12. Push the car on to the material so that the ellow patch is level with the front left-hand corner of
the car. Cabriolet cars must have their soft top up in order to prevent a puddle from accumulating!
13. If TireShoes are to be used these should now be placed underneath the t res.
14. Place some form of oil-spill protection underneath the engine if necessar .
15. Now place the grey Auto-Storm
®
Top-Cover on to the car.
- 2 -

- 2 –
1 . Fold PermaBag over the top of the car and zip up two of the three sides.
17. Slip the Thermo-Hygrometer in to the designated pouch, located behind the see-through window.
18. Remove the transparent plastic wrapping & brown paper from the PermaPack stainless steel
c linders and place the active c linders underneath the car, close to where the zipper ends. Now
zip up the 3
rd
side of PermaBag and locke b means of the Brass Lock included.
19. Finall cover the PermaBag with the Silver Auto-Pyjama
®
Cover (for protection against rain, hail,
snow, dirt and UV-light). Buckle up the 3 straps around the width of the car - one at the front, one
at the centre and one at the back. Proper final strapping will prevent flapping as well as chaffing of
the bod work during wind and storm conditions.
20. There are 3 small loops at the front end and the back end of the Silver Cover. These loops can
be used to prevent the ends of the cover from blowing upwards during storm conditions. A cord
can be passed through these loops and tied underneath the car. The grommets on both sides of
the cover allow for a Cable & Lock, fixed under the car and available as an extra accessor .
21. To regenerate the PermaPack c linders please refer to the separate directions. Store c linders in
a dr , ventilated location when not in use and regenerate prior to next use.
The amount of c linders included is based on central European conditions. If PermaBag is to be
used under hot and humid conditions extra moisture absorbing c linders will be required.
WARNING !
• Petroleum fumes may have accumulated in PermaBag. Do not open close to a flame, do not smoke!
• Never start an engine inside PermaBag.
• PermaBag should be kept away from children and pets.

PermaBag
®
for Outdoor Use
- Strapping Instructions -
Pic 1: La out the securit straps (3 long + 5 short) Pic 2: Unfold PermaBag over the straps
Pic 3: Position car. Cover with gre Car Cover Pic 4: Place the H grometer and PermaPack-
and fold the PermaBag over the car c linders in to the PermaBag and close the zip
Pic 5: Place the Silver Cover on to the car Pic 6: Secure the 8 straps and pull them tight