AVI-8 AV-4072 User manual

SETTING THE TIME
1. Pull the crown out to the 2nd position.
2. Turn the crown clockwise to set hour and minute hands.
3. When the crown is pushed back to the normal position, small second hand
begins to run.
SETTING THE DATE
1. Pull the crown out to the 1st position.
2. Turn the crown clockwise to set the date.
*If the date is set between the hours of around 9:00 PM and 1:00 AM, the
date may not change on the following day.
3. After the date has been set, push the crown back to the normal position.
USING THE CHRONOGRAPH
This chronograph is able to measure and display time in 1/1 second united up
to maximum of 60 minutes.
The chronograph second hand keeps continuously for 60 minutes after
starting. Measuring time with the chronograph
QUARTZ JAPAN CHRONOGRAPH WITH DATE
HOUR HAND
SECOND HAND
MINUTE HAND
NORMAL CROWN
POSITION
1ST POSITION
CHRONOGRAPH
SECOND HAND
BUTTON A
[START / STOP]
BUTTON B
[SPLIT / RESET]
CHRONOGRAPH
HOUR HAND
2ND POSITION
DATE 24H HAND

1. The chronograph can be started and stopped each time button "A" is pressed.
2. Pressing button "B" resets the chronograph and the chronograph second hand
and chronograph minute hand return to zero position.
CHRONOGRAPH RESET (AC FUNCTIONS)
Adjusting the stopwatch sec.
& min. Hand position (clockwise)
Adjusting the stopwatch sec.
& min. Hand position (clockwise)
Timing setting reset
switch second setting
AC FUNCTIONS
( Keep buttons Aand Bpressed at the
same time for 2 seconds, and then,
release the buttons )
• Pull the crown to 2nd position to adjust the chronograph hand position.
• AC functions is available if chronograph hand position is disorderly.
• When using AC functions, chronograph hand moves back and returned to where it was.
(second hand moves 1circle clockwise)
RESET TIME MEASUREMENT STOP
“A” “A”
“A”
“B” “B”
2ND POSITION