BackYardCity Super Tube User manual

Super Tube Spiral Slide
Instructions

5/16” X 1” BOLT W/WASHERS AND LOCK NUT
5/16” X 3/4” BOLT W/WASHER
2 SECTIONS WITH OVER-
LAPPING FLANGES
3 SECTIONS WITHOUT
OVERLAPPING FLANGES
*** THIS PRODUCT IS INTENDED FOR RESIDENTIAL USE ONLY.***
3-1/2” LAG SCREW W/WASHER
Super Tube Spiral Slide

STEP 1: ATTACHING ENTRANCE TUBE TO THE CORNER POSTS







Bottom of large circular opening in

the TOP of the deck.
FACE PLATE
ENTRY











the RIB vertical and the CURVED SECTION facing down. The RIB in the CURVED SECTION will get ro-


-




mid-line and RIB.
Mid-Line
RIB
Rotate RIGHT
TWO holes.
FACE PLATE
ENTRY SECTION

SECTION











Now that the second CURVED SECTION aligning
the RIBS in the sections. The CURVED SECTIONS should make a “U” shape at this point. Rotate the RIB
in the second CURVED SECTION two holes to the LEFT. Fasten the second CURVED SECTION to the 
CURVED SECTION




RIB
second CURVED SECTION





-



EXIT PIECE





Locate the FOOT STAND PIECE. Rotate the FOOT STAND PIECE so that the there is one hole showing on


PIECE.

FOOT STAND PIECE
EXIT SECTION




SECTION so that the foot rests squarely on the ground. Fasten the EXIT SECTION to the second CURVED
Fasten




NOTE: OTHER SECTIONS NOT SHOWN FOR CLARITY.
second
CURVED
SECTION
EXIT SECTION