SportsPlay Equipment 361-509H User manual

361-509H Wheelchair Accessible Sand Digger
Page 1
Rev. 08/04/2004
IMPORTANT
PLEASE READ THESE INSTRUCTIONS BEFORE COMMENCING ASSEMBLY. All
equipment must be installed in accordance with these instructions.
Check your shipment against Bill of Lading and Parts list. Any missing
or broken parts must be reported to your distributor within 10 days of
receipt of your order. When properly installed and maintained,
equipment will give many years of Safe, Trouble-Free use. Periodically
check for loose or broken parts. Loose bolts must be tightened and
broken parts must be replaced as they can possibly create dangerous
situations leading to unnecessary accidents. Resilient Surfacing
should be used under all playground equipment. Appropriate
publications, available at no charge, from the Consumer Product Safety
Commission, include “A Handbook for Public Playground Safety”. You can
receive your free copy by calling 1-301-504-7908.
NOTE: Recommended for children ages 3 and up. Teaches eye/hand
coordination while providing hours of fun.
Bolt Pack:
1 ½” x 1” Hex Bolt
SportsPlay Equipment, Inc., 5642 Natural Bridge, St. Louis, MO 63120 [phone]
www.sportsplayinc.com
1 ½” Flat Washer

361-509H Wheelchair Accessible Sand Digger
Page 2
Rev. 08/04/2004
SportsPlay Equipment, Inc., 5642 Natural Bridge, St. Louis, MO 63120 [phone]
www.sportsplayinc.com
INSTALLATION INSTRUCTIONS
1. Dig a 12” diameter footing hole at a depth that will
place the top of the post 12” above the level of the
sand.
2. Place support post into the center of the footing.
Note: The digger is made to have a 180 degree
restricted turning radius. Be sure to set the post to
the desired turning radius. Pour concrete and plumb
and level the post.
3. Let the concrete set for 72 hours.
4. Place the Digger over the post, placing the ball
bearing between the post and the Digger. Next, insert
1” spacer into the post opening, and using the ½” x 1
½” hex bolt and the ½” flat washer, bolt the Digger to
the support post.
USE AREA: 6 FOOT DIAMETER CIRCLE
Maintenance:
• Periodically check product hardware. Tighten any
that may have become loose.
• Periodically, check product for structural
integrity. If any defects are found, discontinue
use and contact your distributor.
Specifications:
• Bushing size = ½” ID x 1 1/8” OD
• Handles are constructed of ¾” pipe size tubing (1 1/6”
OD)
• Baked on royal blue powder coat paint finish
• Molded aluminum shovel
• ½” ball bearing for ease of turning