Bass Habit Play P12S User manual

P12S
Subwoofer Sealed Enclosure 12”

Thank you for purchasing this Bass Habit enclosure. Please read this manual in order to
fully understand how to get the best result from this product and ensure that the
advices on how to look after the product and the safety precautions are followed.
We hope you enjoy using the product as much as we enjoyed creating it.
THANK YOU!
Before mounting and installing your new enclosure, please read through the whole
user manual. If you have any questions concerning your enclosure or any other Bass
Habit products, contact your nearest Bass Habit distributor.
UNPACKING
INCLUDED IN THE PACKAGING
• P12S passive subwoofer sealed enclosure
• Mounting straps
• User manual

SAFETY & WARRANTY
DO NOT EXPOSE THIS PRODUCT TO EXCESSIVE DAMP OR MOISTURE
- Doing so may result in shock or damage to the product.
BEFORE WIRING, DISCONNECT THE CABLE FROM THE POSITIVE BATTERY TERMINAL
- Failure to do so may result in electric shock or injury.
ENSURE GOOD AND CORRECT CONNECTIONS
- Failure to make the correct connections may result in permanent damage to the product.
DO NOT USE ANY FUNCTIONS THAT MAY TAKE YOUR CONCENTRATION AWAY FROM DRIVING YOUR VEHICLE
- Do not setup your amplifier whilst driving. Doing so may result in an accident. For prolonged interaction
with the product, make sure that your vehicle is stationary and parked in a safe location.
KEEP THE VOLUME AT A LEVEL SO YOU CAN STILL HEAR OUTSIDE NOISE
- Failure to do this may result in an accident. Bass Habit equipment is capable of producing sound levels
that can permanently damage your hearing. Bass Habit recommends caution when listening at a high
volume. For safety and enjoyable listening, the sound should be clear without distortion.
CAUTION
Never connect any speaker lead to the car chassi. This can cause severe damage to your car audio setup.
Before drilling or cutting any holes, investigate the layout of your vehicle thoroughly.
Use caution when working near the fuel/hydraulic lines and electrical wiring.
Observe the correct polarity when wiring. Improper phasing may cause a loss of bass response.
Ensure that no moving parts get caught on the subwoofer or grill.
WARRANTY
All Bass Habit products carry a full warranty depending on the conditions in the country where it is sold. The
warranty is valid from the date of the original receipt as proof of purchase (warranty period differs depending
on local warranty laws and policies). Contact your international Bass Habit dealer or distributor concerning
specific procedure for your country’s warranty policies.
WHAT IS NOT COVERED
• Damage to product due to improper installation.
• Subsequent damage to other components.
• Damage caused by exposure to moisture, excessive heat, chemical cleaners and/or UV radiation.
• Damage through negligence, missuse, accident or abuse. Repeated returns for the same fault may be
considered as abuse.
• Any cost or expense related to the removal and/or abuse. Repeated returns for the same fault may be
considered as abuse.
• Damage caused by amplifier clipping or distortion.
• Items repaired or modified by any unauthorised repair facility.
• Return shipping on non-defective items.
• Products returned without a return authorisation number.
• Damage to product due to use of sealant.
WARNING
Bass Habit equipment is capable of sound pressure levels that can cause permanent damage to your hearing
and those around you. Please use common sense when listening to your audio system and practice safe
sound.
INTERNATIONAL TECHNICAL ENQUIRIES
For international technical support please contact the distribution agent for your country.

INSTRUCTIONS
INSTALLATION EXPERIENCE
Installation of Bass Habit products may require experience with a variety of mechanical procedures. This
manual only provides general installation and operation instructions. If you have any reservations about your
installation skills, please contact your local authorized Bass Habit dealer for help.
INSTALLATION PRECAUTIONS
NOTE! Proceed only if you are a qualified installer, otherwise let your dealer do it.
• Always wear protective eyewear when using tools.
• Turn off all stereo and other electrical devices before you begin.
• Disconnect the (-) negative lead from your vehicle’s battery.
• Never use force when installing a Bass Habit product.
• Locate all fuel lines, brake lines, oil lines and electrical cables when planning your installation.
WIRING EXAMPLES
It is important to know the limits of your amplifier to optimize its performance. Follow the diagram below to
make sure you perform a correct installation of the enclosure.
+-4ohm
CHOOSING LOCATION FOR YOUR SUBWOOFER ENCLOSURE
Choosing a good placement of your Bass Habit product will have the greatest effect of the sound quality of
the system. There are many different considerations needed when choosing the location(s) that best meet
your needs. The location(s) must be large enough for the enclosure to fit. Care is needed to ensure that the
desired location will not affect either the mechanical or electrical operation of the vehicle.
When you have decided on the best location to place your Bass Habit Subwoofer enclosure, secure the
enclosure using the included mounting straps. NOTE! Due to shifting and jarring that will occur in the vehicle
when driving, the mounting straps may stretch or loosen. Please check the mounting straps regularly so that
they are tight and ensures a secure mounting of the subwoofer enclosure.

490MM
340MM
SPECIFICATION P12S
Component
Size
MAX Power
PEAK Power
Impedance
Passive Subwoofer Enclosure
1x300mm (1x12")
300W
450W
4 ohm
RMS Power 150W
Type Sealed
Weight (pc) 11KG
Enclosure Information (P12S)
Volume 32,5L
Subwoofer Information (P300S)
RMS Power 150W
MAX Power 300W
PEAK Power 450W
Impedance 4 ohm
Magnet Ferrite
Subwoofer Frame Material Steel
Sensitivity 87dB
Cone Material Paper / Polypropylene (PP)
Voice Coil Diameter 51mm (2")

The crossed-out wheelie bin symbol means that the product, literature and packaging included must be taken to
separate collection at the end of their working life. Do not dispose of these products as unsorted municipal waste:
dispose of them at a recycling point. For info on your nearest recycling point, check with your local waste
authority.
Winn Scandinavia reserves for possible typos, factual or numeric errors that may have been printed on any
products, package designs, user manuals and/or other included accessories.
Products marked with the RoHS symbol complies with the relevant provisions of the RoHS Directive for the
European Union. In common with all Electrical and Electronic Equipment (EEE) the product should not be
disposed of as household waste. Alsternative arrangements may apply in other jurisdictions.
The product with the CE mark indicates that it has passed the correspondning conformity assessment procedure
and the manufacturer’s declaration of conformity, and it complies with the relevant EU directives, and is used as
a pass for the product to be allowed to enter the European Community market. Relevant directives require
industrial products to be affixed with the CE mark. Those that do not have the CE mark shall not be marketed.
Winn Scandinavia AB
Elementvägen 15, 702 27 Örebro
Sweden
www.winnscandinavia.com