BATHMATE HYDROVIBE User manual

USER GUIDE

Please use this visual guide as this will allow you to utilise the maximum potential of
your HydroVIBE.
On / O󰀨 /
Function button
Pleasure point
Cap
USB Port
LED charging
indicator
Charging socket
The HydroVIBE is not compatible with the HydroXtreme11
Compatible Pumps
How to use your HydroVIBE

2. Replace Cap1. Unscrew Cap & Remove Spacer
3. Slide HydroVIBE Over Pump

4. Insert VIBE Bullets 5. Turn Bullets On
6. During Use 7. Turn Bullets O & Remove

8. Remove HydroVIBE
9. Clean & Store

HYDROTHERAPY RING CARE INSTRUCTIONS
This product is for use on your hydropump only, do not use directly on
the body.
• Do not use this product for longer than the recommended routine time outlined in
your hydropump user guide.
• Do not use this product whilst under the inuence of alcohol or drugs.
• Avoid use if you are taking blood thinning medication.
• If pain or discomfort occurs discontinue immediately.
• Seek medical advice before use.
VIBE BULLET CARE INSTRUCTIONS
Take care when using your Vibe for the rst time, vibration can be intense.
• This product is for external use only.
• This product is not a children’s toy. Adult use only.
• To avoid injury or aggravation of pre-existing conditions, this device should not be
used on swollen or inamed areas or skin lacerations.
• No medical claims are warranted or implied by use of this product.
• Clean your Vibe after every use.
• Take care when cleaning your Vibe, avoid getting the charging socket wet.
• Keep this product clean and ensure that it is fully dry before storing in a safe, dry
place, moisture can damage batteries and motor.
• Do not expose this product in water above 60°C
• Always allow your Vibe to cool down before storing in a safe place, it is electrical
and motors get warm with use.
• Excessive usage of this product will wear out the motor and may cause it to
overheat. If you feel that your Vibe is getting unduly hot, switch o󰀨 and allow to
cool down before continuing use.
• Seek medical advice before use.
CHARGING YOUR VIBE BULLETS:
This product contains a Lithium Rechargeable Battery. If battery leakage occurs, stop
using immediately and avoid contact with skin. If skin contact occurs, immediately
wash the area thoroughly with warm soapy water. If liquid leakage comes into
contact with eyes or body tissue, immediately ush thoroughly with water and see
a doctor. Treat this product with care to avoid battery leakage, combustion and
explosion. Do not expose the battery to excessive physical shock. Do not take apart
or attempt to repair the Vibe or battery. Do not touch the terminals of the Vibe with
any metal objects.
The product may be partially charged on purchase but we recommend a full charging
cycle before rst use. Charge for at least 2 hours before rst use. Do not switch on or
use the product during the rst charge cycle as this may a󰀨ect the battery capacity.

• Before charging, ensure that your Vibe and the USB charging cable are dry.
• Unscrew the cap to reveal the charging socket.
• Connect the USB charging cable into a suitable USB charging port and connect to
the Vibe through the charging socket.
• The LED charging indicator will glow RED to indicate that the Vibe is charging.
• Once fully charged, the LED indicator will glow GREEN.
• Once charged, remove the cable and gently replace the cap by screwing onto
the body. IMPORTANT: Take care not to cross-thread the cap as this could allow
water ingress.
• Do not use your Vibe with the cable attached or whilst charging.
• Only use the USB cable supplied with this product.
• Do not use the charging cable if it is damaged.
• Always disconnect charger cable before cleaning.
The bullet will take approximately 2 hours to fully charge from empty and will give
you approximately 60 minutes use between charges.
USING YOUR BATHMATE HYDRO VIBE
IMPORTANT: Your Bathmate Vibe Bullets will arrive in transportation mode.
Before using your Vibe remove the plastic spacer by unscrewing the cap and
gently sliding o󰀨.
• Slide the Hydrotherapy ring over your hydropump.
• Insert the 2 Vibe Bullets.
• Press the on/o󰀨 button to switch on.
• Continue to press the on/o󰀨 button to cycle through the 10 di󰀨erent intensity
patterns to nd your preferred pleasure wave setting.
• Use in conjunction with the recommended routine time outlined in your hydropump
user guide.
• Press and hold the on/o󰀨 button for 2 seconds to switch the Vibe Bullets o󰀨 and
remove from the Hydrotherapy Ring.
• Remove the Hydrotherapy ring from your hydropump.
• Clean and dry the Hydrotherapy Ring and Vibe Bullets and store away.
ENVIRONMENTAL PROTECTION
Products marked with this symbol should not be treated as household waste.
Instead, take it to a recycling centre that deals with electrical and electronic
equipment.
WARRANTY
The Bathmate Hydro Vibe and Vibe Bullets are designed to provide many years of
trouble free use. They are covered by a 1 year warranty against defective parts or
poor workmanship. Full details of the warranty and what to do in the unlikely event
that your Hydro Vibe or Vibe Bullets are faulty can be found at:
www.bathmatedirect.com/support.

Bathmate is a worldwide registered trademark.
Application no: EU: 005210224, USA: 3789395, China: 10221454. Design
Registration in Europe: 000556972, China: 200930189877.X Patent no: UK:
GB24178686 EU: 1799162, USA: 7651463 Australia: 2005278999.
©Worldwide copyright protection - DX Products Ltd
Manufactured in China, assembled in the UK by DX Products Ltd
Unit 1, Horbury Junction Industrial Estate, Calder Vale Road,
Horbury, Wakeeld, WF4 5ER, UK
[phone] [email protected]
https://uk.bathmatedirect.com/pages/user-guides
Scan the QR code below to access alternative
languages and further support.
日本語
РУССКИЙ 中文
FRANÇAIS ESPAÑOL ITALIANODEUTSCHE PORTUGUÊS