BC SKY 1745 User manual

SKU# SKY 1745
ASSEMBLY MANUAL
DUAL KEYBOARD STAND
Revised August 2014

The parts and hardware below have been included for assembly:
Washers x 2
Top Arms x 2
Middle Arms x 2 Feet x 2Stand 1 x 1
Knob x 2
Small Screws x 2 Allen Wrench x 1
Lower Arms x 2 Middle Pole x 1
Stand 2 x 1
Take X Stand 1 and attach it to the feet using two
Large Screws & Allen Wrench.
• Make sure adjustment knob is facing outwards.
• Adjust to desired width before proceeding to
Step 2.
Take X Stand 2 and attach using two
Large Screws to the remaining holes in the feet.
Attach two Lower Arms to either side of the X
Stands using 4 large screws as shown.
1
2
3
Large Screws x 10
WARNING:
Manufacturer and seller expressly disclaim any and all liability for
personal injury, property damage or loss, whether direct, indirect, or
incidental, resulting from the incorrect attachment, improper use,
inadequate maintenance, or neglect of this product.
Next, attach two Middle Arms to both sides of the
Lower Arms using 2 Small Screws.
4

Slide the Middle Pole in between the two Middle
Arms in the appropriate holes and screw on 2
Knobs on each side with a Washer on each side.
Lastly, attach the 2 Top Arms to each sides of the
Middle Arms, and tighten with 2 Large Screws.
•Makesureendtabsarefacingupward.
5
6
Ca Us!
We’re here 7 days a week to help you!
(909)-948-8400
Monday-Friday 5:00am-5:30pm pst
Saturday and Sunday 7:00am-3:30pm pst