Be-bella Quadturbo shine User manual

New compact and lightweight hair dryer now comes in 6 new colours with a

nice shine finish!

The new Be Bella™ Quadturbo Shine hair dryer offers all the professional

performance, power and speed you will ever need to generate soft movement.

The Quadturbo Shine hair dryer gets maximum power thanks to its AC motor.

The body can withstand high temperatures without becoming out of shape or

overheating. It has 4 temperature settings and 2 speed controls.

TECHNICAL CHARACTERISTICS:

• AC Motor • Cool shot button

• Power: 2000 Watts • Airflow: 60m3/h

• Voltage: 220/240V • 2.8m cord

• 2 speeds and 4 temperature settings • Weight without cord: 522gr

• Temperature: 130˚C • Filter with round metallic grille

HOW TO USE THE HAIR DRYER

1. Make sure that your hands are completely dry before plugging in the device.

2. Plug it in and set switch to required settings. Once you have finished using it,

please, switch it off and unplug it.

NOTICE

1. Do not switch on before checking that voltage on the specificationc plates is

the same as the electrical installation’s one.

2. Switch it off when it is not in use, even if it is only for a moment.

3. If the cord is damaged it must be replaced by the manufacturer or its service

agent or a similar qualified person, in order to avoid hazards.

4. Never submerge or wet the device.

SAFETY INSTRUCTIONS

• Ensure that the air’s input and output are not blocked or obstructed.

• If that supposition happens, thermal temperature limiter guards avoid

overheating and the hair dryer would stop working until it is cool again.

KEEPING, CLEANING & CARE

• Children may not use this appliance when there is no adult present.

• It is not advisable to use the appliance with wet hands.

• If cord is damaged, do not use the device and send it to an authorised service

center to be repaired.

• While the device is working, it must not be covered or involed with any clothes in

order to avoid obstructing the air’s input and output.

• Please unplug your hair dryer before you start cleaning it.

• Please do not wet, dampen or submerge this device into or with any liquid.

• To use the hair dryer to its optimum, it is essential to often clean the device’s

surface and remove remaining fluffs and dust in order to keep air entrance free

of remaining elements.

• Please clean this appliance with a slightly damp cloth and dry it up with a dry

cloth. Please do not use chemical aggressive products to clean this hair dryer.

TO REDUCE THE RISK OF DEATH OR INJURY BY

ELECTRICAL SHOCK:

1. Always unplug appliance immediately after using.

2. Do not place or store appliance where it can fall or be

pulled into a tub or sink.

3. Warning: Do not use the appliance near a bath tub, wash basin or other vessel

filled with water. Never place the appliance in water or any other liquid.

4. If appliance falls into water, unplug it immediately. Do not reach into water.

WARNING

1. This appliance should never be left unattended when plugged in.

2. Never operate this appliance if it has a damaged cord or plug or has been

dropped into water. Return the appliance to place of purchase for examination

and repair.

3. Keep the cord away from heated surfaces.

4. This appliance is not intended for use by persons (including children) with

reduced physical, sensory or mental capabilities, lack of experience and

knowledge, unless they have been given supervision or instruction concerning

use of the appliance by a person responsible for their safety.

5. Children should be supervised to ensure that they do not play with

the appliance.

6. When the hair dryer is being used in a bathroom, unplug it after use as the

proximity of water presents a serious hazard even when the hairdryer is

switched off.

In accordance with European Directives 2002/95/CE, 2002/96/CE and 2003/108/CE on the restriction of the use of dangerous substances in electric and

electronic equipment as well as their waste disposal.

The barred symbol of the rubbish bin shown on the equipment indicates that at the end of its useful life, the product must be collected separately from

other waste. Therefore, any products that have reached the end of their useful life must be given to waste disposal centres specialising in separate

collection of waste electrical and electronic equipment, or given back to the retailer at the time of purchasing new similar equipment, on a one for one basis.

The adequate separate collection for the subsequent start-up of the equipment sent to be recycled, treated and disposal of in an environmentally

compatible way contributes to preventing possible negative effects on the environment and health and optimises the recycling and reuse of components making up the