BENEITO FAURE KORA 25W LED User manual

INSTRUCTIONS FOR USE
(to be carefully stored for further consultaon)
Read these warnings carefully before installing the ceiling.
1. Remove the apparatus from the packaging and check its integrity. In case of doubt do not proceed to the assembly and
contact your reseller.
2. Do not install the device in an environment without adequate venlaon.
3. Before the electrical connecon it is necessary to check that the data of the power supply network correspond to those
specified in this manual.
4. The electrical connecon shall be made by qualified personnel. Before making the electrical connecon, make sure you
have removed voltage from the grid.
5. Do not misuse the device (different use for which it was designed). The manufacturer may not be held liable for damage
resulng from improper, erroneous and unreasonable uses.
6. Do not install the device in environments with dangerous atmospheres.
7. Installaon shall be carried out as instructed by the manufacturer; incorrect installaon may cause damage to persons,
animals or things for which the manufacturer cannot be held liable.
8. Do not allow the device to be used by children or disabled persons without supervision.
9. Cleaning is restricted to the external surface of the appliance.
NOTE: DO NOT use DETERGENTS, DETERMINATIONS, WINDOW DETERMINATIONS, PLASTICS AND THE like. Use only a so,
slightly moist pan.
10. In case of malfuncon, do not tamper with the device. For repair, please contact qualified personnel.
11. Do not aach the device to a fragile wall or in bad condion.
PART OR SUBSTANCE INSTALLATION
1. Remove the staff by pressing inwards and simultaneously the two buons placed at the ends of the ceiling (Fig. 1a and
1b). The staff will detach automacally.
2. Aach the bar to the wall using the two les (fig.2).
3. Make electrical connecons respecng the voltage and frequency indicated on the plate data and respecng the
specified L -N polarity). Make sure that no conductor has exposed copper fragments.
2.700K 3.000K 4.000K
SWITCH
KORA 25W LED
COD. 4500-V2, 4499-V2

4. Select the desired colour temperatu r e .
5. Mount the ceiling on the stand with a slight but firm pressure. The ceiling will automacally hook up.
6. In case it is necessary to remove the cap from the stand: press inwards and simultaneously the 2 -buon posions at the
end of the cap unl the detachment takes place.
+45ºC
-25ºC >85
CRI
25.000h
IP54
3
A
R
W
R
S
A
R
N
A
T
E Y
Y
NOT DIMMABLE
RoHS
220-240v
5
PC +PC 120 lm/w
IK08
50Hz
0,18A
Pf: 0,9
3.000 lm 110º
2.700K 3.000K 4.000K
SWITCH
3-4 5 6
Políg. Valldoriolf C/Thomas Edison 4-6
08430 La Roca del Vallés (Barcelona) Spain
Tel.: [phone] www.beneito-faure.com
B-63378673 Made in P.R.C. WEEE DE98004440