Images for illustration purposes only – Product may differ slightly from the one shown
Safety
Cleaning care
The lamp can be cleaned with a clean dry cloth. Do not immerse it in water.
Always switch off the supply before cleaning
READ ALL INSTRUCTIONS Installation Instructions
Parts Supplied
x1 x20
SXLS 31362E
SXLS 31362ES
The electrical supply to the unit should be provided by connecting to a circuit protected by
a fuse or miniature circuit breaker suitable for the electrical rating of the unit.
Any plug, sockets and switches intended for use outdoors must have a water IP rating as
good as, or better than, the protection rating of this unit.
These instructions are for your safety. Please read through them thoroughly prior to installation
and retain them for future reference.
Always organise cables and extension leads so that they will not be a trip hazard
The external flexible cable or cord of this luminaire cannot be replaced; If the cord is
damaged, the luminaire shall be destroyed.
Check the pack and make sure you have all of the parts listed.
Remove all packaging, wrap etc. from the product.
Decide on the appropriate location for your product.
IP44 product: Protects against solid objects over 1mm and sprays from all directions.
Limited ingress permitted.
Always refer to the installation drawing for the orientation of the product.
Never put anything on the product or hang anything on any part of this product.
When the product does not light after installation:
> Ensure there is no electricity failure
> Ensure all the connections are secured
Always disconnect the product from mains at least 10 minutes allowing to cool down before
any maintenance or adjustment.
CAUTION: Do not stare at the operating LED light source.
Do not use this product coiled up or when still in its packaging.
Do not connect to power source until correctly located in desired position.
Always disconnect from the power source before relocating this item.
Do not extend by connecting to other products
