Bergman PRO XK01-40A User manual

20V Cordless Pressure Washer
Product Code: 3206741
Instruction Manual
Please retain this manual for future reference

4
Scotts Ltd. Cotswold House, 1 Crompton Road, Groundwell, Wiltshire. SN25 5AW
Enquiries: 0344 482 9700
www.bergmantools.com
4. Charging the battery pack
IMPORTANT: Before use, ensure the battery is charged.
The battery pack as a power indicator, press the button on the pack to see the current state of charge.
To charge the battery remove it from the pressure washer (for best results charge at room
temperature). Charging must be done indoors.
Connect the battery pack to the charger supplied as shown below. Connect the charge to mains
power. The LED indicator will show the following:
Flickering
Battery Charging
Full Steady Light
Charging Complete
No indicator light
Charging fault
Please ensure the battery is disconnected from the charger once charging is complete and charger is
unplugged from the mains power.
NOTE:
1. The lithium battery pack supplied is not fully charged. It is recommended the battery be fully charged before
first use.
2. Please ensure charging is carried out in a ventilated and dry environment. The complete charging process
takes about 1 to 5 hours.
3. During use, when the machine automatically switches from high to low pressure mode this indicates that the
battery power has insufficient and requires charging.
4. When the power is too low, the machine will automatically power-off to protect the battery. Please charge
immediately. Battery should not be left flat is can cause permanent damage to the battery.
OPERATING INSTRUCTIONS
Please follow the above instructions to assemble and configure the pressure washer ready for use. Once
assembled, ensure the water inlet hose is submerged in water and the extension pipe and or accessories are
correctly fitted and secure.
To operate; point at the ground and squeeze the handle trigger to start the pressure washer. Release the
trigger to stop.

5
Scotts Ltd. Cotswold House, 1 Crompton Road, Groundwell, Wiltshire. SN25 5AW
Enquiries: 0344 482 9700
www.bergmantools.com
TROUBLE SHOOTING
Description
Possible Cause
Solution Suggestion
Lithium battery power indicator flickering
Low battery
Battery Charging
No power on after machine on
Low battery
Battery Charging
Stop working unexpectedly
High temperature, automatic protection
Turn on after the heat temperature drops
Battery not charging
The battery and charger are not
connected.
Reinsert the battery into the charger to
make sure the connection is good.
The charger is not connected to the
power supply.
Check to see if the LED is illuminated on
the charger (if LED is not lite, there is no
power to the charger, try a different wall
socket.
Low water flow
Blocking of the filter
Clean the filter and water inlet filter
Water inlet pipe is folded
Unfold or replace the water pipe
Impurities in water
Change it into clean water
Blocking of the jet pipe
Clean the jet pipe
No water suction
Wrong connection of the water pipe
connector and water inlet
Connect the inlet pipe connector to the
machine water inlet in place
The water pipe filter is not fully inserted
into the water
Insert the water pipe filter fully into the
water
The water inlet seal ring is off or
damaged
Install or replace the seal ring
Long waiting time for water coming out
The cleaner is on Eco mode
Switch to Auto mode
Low water flow
Refer to the solution of low water flow
Leakage of water outlet
jet pipe or extension pipe is not installed
in place
Install the jet pipe with extension pipe or
the cleaner host in place

6
Scotts Ltd. Cotswold House, 1 Crompton Road, Groundwell, Wiltshire. SN25 5AW
Enquiries: 0344 482 9700
www.bergmantools.com
OTHER WARNINGS AND CAUTIONS
Do not put the higher-pressure cleaner near any fire source or any other high temperature places.
Do not expose lithium battery pack in heat or fire source and avoid storage in the direct sunlight environment.
Do not make the lithium battery pack subjected to mechanical impact.
Do not make lithium battery pack short-circuit. Don’t place the pack in boxes or drawers at will to avoid short-circuiting each
other or being short-circuited by other metal objects.
Do not disassemble and open the lithium battery pack.
Please keep away from children.
Do not charge the lithium battery for a long time.
It is recommended to charge the lithium battery pack every three months when it is not in use for a long time.
Please discontinue use when the product accidentally falls to the ground, showing visible damage or failure.
The performance of lithium battery pack is the best under normal temperature (20℃± 5℃).
Please use dry cloth to wipe products for cleaning. Do not use water, gasoline, alcohol and other chemical solvents.
Please clean the water inlet filter and water pipe filter regularly.
Waste batteries should be classified for recycling and do not thrown into dustbins at will.
Do not use the supplied charger on any other device.
Do not charge at high temperature.
Charge only indoors and prevent getting wet in the rain.
If the power cord is damaged, it must be replaced by the manufacturer, its maintenance department or similar professionals
to avoid danger.
Please check whether the charger is in good condition before charging.
Improper use of high-pressure jet pipe can be dangerous. Do not point the jet pipe directly at people, animals, charged
devices or the cleaner itself.
Do not shoot water at the equipment containing electrical components.
TECHNICAL DATA
Host Model
XK01-40A
XK01-20A
Charger Voltage/Frequency
110~240V 50/60Hz
110~240V 50/60Hz
Charging Current
500~1000mA
500~1000mA
Charging Time
3~5 hours
3~5 hours
Rated Voltage
40V Max
20V Max
Rated
Pressure
Auto Mode
3.5 MPa
2.2 MPa
Eco Mode
2.2 MPa
0.65 MPa
Max Pressure
6.0 MPa
3.5 MPa
Rated Flow
Auto Mode
150 L/h
120 L/h
Eco Mode
120 L/h
65 L/h
Max Flow
200 L/h
170 L/h
Maximum Water Inlet
Pressure
0.7 MPa
0.7 MPa
Height of Water Suction
Max 1.2 Meter
Max 1.2 Meter
Executive Standard
IEC60335-2-79
IEC60335-2-54

7
Scotts Ltd. Cotswold House, 1 Crompton Road, Groundwell, Wiltshire. SN25 5AW
Enquiries: 0344 482 9700
www.bergmantools.com
DISPOSAL AND RECYCLING
The crossed out Wheelie Bin logo is used to highlight electrical products that should
not be disposed of with normal household waste. Scotts Ltd has contributed to the
funding of an alternative network of UK recycling facilities.
Please visit www.recycle-more.co.uk to find where you’re nearest recycling point is
and recycle this product at the end of its life.
Made in China
For:

8
Scotts Ltd. Cotswold House, 1 Crompton Road, Groundwell, Wiltshire. SN25 5AW
Enquiries: 0344 482 9700
www.bergmantools.com
QUICK START GUIDE
STEP 1. Charge and Install the battery pack
STEP 2: Connect the extension pipe, jet pipe and soap dispenser to the pressure washer.
STEP 3: Connect the water inlet hose
STEP 4: Squeeze the handle trigger and your away.
Water inlet hose here
On/off trigger switch