Bertoni ZIPPY User manual

MANUAL INSTRUCTION
baby cot
ZIPPY
1 layer

IMPORTANT! KEEP FOR FURTHER REFERENCES.
READ CAREFULLY!
SAFETY REQUIREMENTS
EN
1. The baby cot is ready for use only when unfolded and the locking mechanisms are well fixed!
2. Warning! When the baby stands up unaided, the lowest position of the cot is the safest one!
3. Warning! Do not leave any items in the cot that might be used for climbing or might injure the baby!
4. Warning! When choosing a mattress, keep in mind that:
- the distance between the surface of the mattress and the edge of the cot must be at least
500 mm when the base is in the lowest position and 200 mm when is in the highest position!
5. WARNING! DO NOT USE THE COT NEAR OPEN FIRE OR HEATING DEVICES!
EN 716-1,2,3 EN 1130-1,2
ATTENTION! If you use the cot outdoors, please clean all parts throughly after each use.
Cleaning. To clean use soapy water or soft cleaning detergent. Handwash the bag with soapy water.
Do not iron. Do not bleach.
ATTENTION! Do not put bulk objects in the cot that can help the baby to jump out from the cot. Do
not place the cot near heating devices because it will damage the plastic and fabrics.
ATTENTION! Use the cot regarding to these instructions!
MAINTENANCE AND CARE
PARTS
1. Cot - 1 pc.
2. Mattress - 1 pc.

7

ASSEMBLING OF THE COT
1. Unpack the cot from the bag. (picture 1)
2. Put away the mattress which is placed around the cot by unsticking the three soft bonds. (picture 2)
3. Unfold the cot at half. (picture 3)
4. Catch the middle part of the long upper tubes and lift it up till the mechanism situated in the middle
of the tube is locked. In the same time the vertical tubes (baby cot legs) should be close to each other
at its lower end which provides the easy locking of mechanism. (picture 4)
5. Repeat the same procedure with the rest of the upper tubes. Check if the lockers of each one are
well locked by slightly pressing downwards the middle part of the tube.
6. Press downwards till the lower tubes are straightened and locked. Then the all sides are
straightened and stabled. (picture 5)
7. Unfold the mattress and put it on the bottom of your cot. (picture 6)
8. Your cot is ready to use. (picture 7)
DISMANTLING OF THE COT
1. To dismantling the cot, repeat the same steps as in mounting in the reverse order:
- remove the mattress;
- lift the bottom by using the knot in the middle;
- pull the trigger’s mechanism to unlock it ( for both tubes), then release the arm downward;
ATTENTION!
For easier unlock of the mechanism by pressing the buttons you need to lift the tube up. Тhe hard
pushing of the tube downward with locked mechanism leads to serious damage!

www.bertoni-eu.com
Дидис ООД - България
Шумен 9700, “Правда” 1
Тел.: [phone]
Факс: [phone]
e-mail: [email protected]
Didis Ltd. - Bulgaria
Shumen 9700, “Pravda” 1 Str.
Tel.: [phone]
Fax: [phone]
e-mail: [email protected]