Bestway 53310 User manual

WE SUGGEST NOT TO RETURN
THE PRODUCT TO THE STORE
QUESTIONS? PROBLEMS?
MISSING PARTS?
For FAQ, Manuals, Videos Or
Spare Parts, Please Visit
bestwaycorp.com/support
V
i
s
i
t
w
w
w
.
b
e
s
t
w
a
y
c
o
r
p
.
c
o
m
/
s
u
p
p
o
r
t
f
o
r
h
e
l
p
OWNER’S MANUAL
bestwaycorp.com/support
Visit Bestway YouTube channel

IMPORTANT SAFETY INSTRUCTIONS
PLEASE READ THESE INSTRUCTIONS
CAREFULLY BEFORE USING THIS PRODUCT.
FAILURE TO FOLLOW THESE INSTRUCTIONS
COULD RESULT IN SERIOUS INJURY OR DEATH.
WARNING
1. Adult assembly required.
2. Place the product on a level surface at least 3m from any structure or obstruction such as a fence, garage,
house, overhanging branches, laundry lines or electrical wires.
3. Recommend back towards the sun when playing.
4. Only for domestic use.
5. For outdoor or indoor use.
6. Inflatable device should be installed over impact absorbing surfaces such as sand, wood-bark chips, rubber
and foam and should not be installed over concrete, asphalt or any hard surface.
7. This toy is not safe if the anchorage system is not used as it may be lifted by light winds. Do not use the product
if wind speed exceeds 20 mph.
8. Use of this product may cause friction burns to exposed skin. Ensure that clothing fully covers arms and legs,
as well as the torso.
9. Children may be injured by falling onto inflation devices. Ensure that inflation devices are positioned at least
2.5m from the toy.
10. Keep assembly and installation instructions for further reference.
11. Failure to follow the installation and operating instructions present a risk of serious injury or death.
12. Always check all anchors before and during use.
13. Children must remove helmets, loose clothing, scarves, headgear, shoes and glasses, as well as any sharp or
hard objects from their pockets, as they may puncture the bounding surface.
14. To prevent electric shock, do not clean the blower with water.
15. Do not use extension cord with this product.
16. Do not allow users to do somersaults or rough play.
17. Do not allow food, drink or gum inside unit.
18. Do not allow users to climb or hang on containment walls.
19. Always keep the entrance free from obstruction.
Product Description
Item
53310
Age Maximum number of users Maximum weight capacity Maximum fall height
3-8 years 3 113kg (250lbs) 140cm/55”
WARNING FOR AIR BLOWER
1. When the appliance is not in use and before cleaning, unplug the appliance from
the outlet.
2. To protect against the risk of electrical shock, do not immerse the unit, cord or
plug in water or other liquid.
3. DANGER! Unplug or disconnect the appliance from the power supply before
maintenance.
4. This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety. Children should be
supervised to ensure that they do not play with the appliance. (For market other
than EU).
This appliance can be used by children aged from 8 years and above and
persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards
involved. Children shall not play with the appliance. Cleaning and user
maintenance shall not be made by children without supervision. (For EU market).
5. If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
BLOWER OPERATION
ON/OFF SWITCH
OFF — O
ON — l
2

WARNING FOR AIR BLOWER
1. When the appliance is not in use and before cleaning, unplug the appliance from
the outlet.
2. To protect against the risk of electrical shock, do not immerse the unit, cord or
plug in water or other liquid.
3. DANGER! Unplug or disconnect the appliance from the power supply before
maintenance.
4. This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety. Children should be
supervised to ensure that they do not play with the appliance. (For market other
than EU).
This appliance can be used by children aged from 8 years and above and
persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards
involved. Children shall not play with the appliance. Cleaning and user
maintenance shall not be made by children without supervision. (For EU market).
5. If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
Consumer information sheet for playground surfacing materials
The US Consumer Product Safety Commission (CPSC) estimates that about 100 000 playground
equipment-related injuries resulting from falls to the ground surface are treated annually in US hospital emergency
rooms. Injuries involving this hazard pattern tend to be among the most serious of all playground injuries, and have
the potential to be fatal, particularly when the injury is to the head. The surface under and around playground
equipment can be a major factor in determining the injury-causing potential of a fall. It is self-evident that a fall on to
a shock-absorbing surface is less likely to cause a serious injury than a fall onto a hard surface. Playground
equipment should never be placed on hard surfaces, such as concrete or asphalt, and while grass may appear to
be acceptable, it may quickly turn to hard-packed earth in areas of high traffic. Shredded bark mulch, wood chips,
fine sand or fine gravel are considered to be acceptable shock absorbing surfaces when installed and maintained
at a sufficient depth under and around playground equipment.
Below lists the maximum height from which a child would not be expected to sustain a life-threatening head injury
in a fall on to four different loose-fill surfacing materials if they are installed and maintained at depths of 150mm,
225mm and 300mm.
Fall height in millimeters from which a life-threatening head injury would not be expected
Type of material
Double shredded
bark mulch
Wood chips
150 mm
1800
1800
1500
1800
3000
2100
1500
2100
3300
3600
2700
3000
225 mm 300 mm
Fine sand
Fine gravel
Depth of surfacing material
However, it should be recognized that all injuries due to falls cannot be prevented, no matter what surfacing
material is used.
It is recommended that a shock absorbing material extend a minimum of 1800mm in all directions from the
perimeter of stationary equipment such as climbing frames and slides. However, because children may deliberately
jump from a moving swing, the shock absorbing material should extend in the front and rear of a swing a minimum
distance of twice the height of the pivot point measured from a point directly beneath the pivot on the supporting
structure.
This information is intended to assist in comparing the relative shock-absorbing properties of various materials. No
particular material is recommended over another. However, each material is only effective when properly
maintained. Materials should be checked periodically and replenished to maintain correct depth as determined
necessary for the equipment in question. The choice of a material depends on the type and height of the
playground equipment, the availability of the material in a particular area, and its cost.
This information has been extracted from the CPSC publications “Playground Surfacing — Technical Information
Guide” and “Handbook for Public Playground Safety”.
3

Assembly
Setup Instruction
Placement:
Use on a flat, grassy area only. Do not use on pavement or hard surfaces. Usage area
should be free of rocks, bumps, holes, sticks, etc. The slide park setup location should
have a minimum distance of 10ft (305cm) from any free-standing structures or
obstructions.
This include: houses, garages, fences, trees, playground equipment, large rocks, etc.
Note: 1. Place on level ground and firm grass or soil to allow proper use of stakes.
2. Stakes should be placed at an angle for better anchorage, should be driven under the
ground to reduce tripping and tipping hazards.
Attention: After inflation, the blower should run continuously while children are playing.
MAINTENANCE OF SLIDE PARK
1. Check the product for damage at the beginning of each season and at regular intervals when in use.
If these checks are not carried out, the activity toy could overturn or otherwise become a hazard.
2. Clean the product and remove any accumulated debris before each use. Wipe the product using a
dry cloth or a cloth dampened with a neutral, non-flammable, non-toxic cleaning and sanitizing
solution or pure water.
MAINTENANCE OF AIR BLOWER
The source of electrical supply must be disconnected prior to
any servicing or cleaning.
1. Use a dry cloth to gently clean all surfaces.
2. Store in a cool, dry place and out of children’s reach.
10ft.(305cm)
10ft.(305cm)
safety area
4

Deflation & Storage
Troubleshooting
Repair Patch Instructions
IMPORTANT: All children must exit the slide park before deflation.
IMPORTANT: Store park in a secure place, away from children, to prevent suffocation. Never leave
either the park or the blower outside when not in use.
1. Turn off the blower motor and unplug it from the outlet.
2. Remove stakes from the park and the blower.
3. Fold the slide park toward the center.
4. Roll up the slide park tightly and compress the fabric to expel all of the remaining air.
5. Slip the carrying bag over the rolled-up inflatable park. Flip the bag and the park over, close the
bag, and store the park and the blower in a dry place.
12
correct
incorrect
or
1. Deflate the item, clean the area and allow to dry thoroughly.
2. Cut a portion of the patch to the size needed and round the corners.(See Fig.1&2).
3. Apply the repair patch:
Option #1: Using the vinyl patch.
Remove the adhesive backing from the patch material, position the patch over the damaged area and smooth out any bubbles.
Option #2: Using the fabric patch and the glue (not included).
Apply only the amount of glue(not included) needed to cover the repair site and press patch firmly over the puncture.
4. Allow to sit for 30 minutes before re-inflating.
Warning:Repair patched must be applied by an adult only. Keep out of children.
Replace defective parts in accordance with the instructions.
Please keep for future reference.
PROBLEM CAUSE
Motor won’t run
Motor runs but wheel makes a scraping noise
1. Switch not turned on.
2. The circuit is opened or it is poor contact.
3. Electric capacity is damaged.
4. Choked up by hard objects.
1. Screws on the vaned wheel are loose.
2. Foreign objects in air-blower.
1. The voltage is unstable.
2. Motor is affected with damp.
3. Electric capacity is failure.
4. The impeller is loose.
Motor is unable to run normally
5

6
003x2
004x9 005x1 006x1
4
5
6
7
1 2 3
001x1
P05773
002x1
P04508

For support please visit us at:
bestwaycorp.com/support
©2020 Bestway Inflatables & Material Corp.
All rights reserved/Tous droits réservés/Todos los derechos reservados/Alle Rechte vorbehalten/Tutti i diritti riservati
®™ Trademarks used in some countries under license to/
Marques ®™ utilisées dans certains pays sous la licence de/
Marcas comerciales ®™ utilizadas en algunos países bajo la licencia de/
®™ Die Warenzeichen werden in einigen Ländern verwendet unter Lizenz der/
®™ Marchi utilizzati in alcuni paesi concessi in licenza a
Bestway Inflatables & Material Corp., No.3065 Cao An Road, Shanghai, 201812, China.
Manufactured,distributed and represented in the European Union by/
Fabriqués, distribués et représentés dans l’Union Européenne par/Fabricado, distribuido y representado en la Unión Europea por/
Hergestellt, vertrieben und in der Europäischen Union vertreten von/Prodotto, distribuito e rappresentato nell'Unione Europea da
Bestway (Europe) S.r.l., Via Resistenza, 5, 20098 San Giuliano Milanese (Milano), Italy
Distributed in North America by/Distribués en Amérique du Nord par/Distribuido en Norteamérica por
Bestway (USA) Inc., 3411 E. Harbour Drive, Phoenix, Arizona 85034, United States of America
Tel: [phone] (For U.S. and Canada)
Distributed in Latin America by/Distribué en Amérique latine par/Distribuido en Latinoamérica por/Distribuído na América Latina por
Bestway Central & South America Ltda, Salar Ascotan 1282, Parque Enea, Pudahuel, Santiago, Chile
Distributed in Australia & New Zealand by Bestway Australia Pty Ltd, Unit 2/98-104 Carnarvon St Silverwater, NSW 2128, Australia
Tel: Australia: ([phone]; New Zealand: 0800 142 101
Exported by/Exporté par/Exportado por/Exportiert von/Esportato da
Bestway (Hong Kong) International Ltd./Bestway Enterprise Company Limited
Suite 713, 7/Floor, East Wing, Tsim Sha Tsui Centre, 66 Mody Road, Kowloon, Hong Kong
www.bestwaycorp.com
303021241087