Betso S107 User manual

S107 Cordless 22.2V Stick Vacuum Cleaner
Quick Start Guide
Safety & Warnings
Overview & Accessories
Assembly Instructions
Operation
Cleaning & Care
Specification
Troubleshooting

To reduce the risk of fire, electric shock or injury to persons or property, the following
basic safety precautions should always be followed.
Never use this appliance with a damaged cord, plug or other damaged parts.
Check if the voltage indicated on the lab corresponds with the local mains
voltage before you connect the appliance.
Always ensure the charging connector, cord and plug are dry. Never immerse
the appliance into the water or any other liquid. Do not rinse it under a tap
except for the cyclone cone, the HEPA filter and the rolling brush parts.
Always ensure that your hands are dry before removing the plug from the main
outlet. Never pull the plug out of the mains outlet by its cord.
Children should always be supervised to ensure that they do not play with this
appliance.
The appliance should not be used by adults or children who lack experience,
product knowledge or disability which might cause a hazard, unless they have
been correctly instructed.
Always keep the battery pack far from fire and flammable items.
Never use this appliance to suck liquids, glass, metal fragments and burning
things such as ashes, cigarette butts, matches and so on.
Always ensure that the dust cup and the battery pack are installed before using.
If the cord, plug and any other parts get damaged or the appliance fall into
water, please stop use and immediately unplug from the main power. Never
disassemble the main body, repair or replace any parts by yourself.
Do not use non-original parts with the unit as it may cause damage.

Accessories
Adaptor User's manual
Crevice tool Stretch brush
Mattress brush

The appliance is packed as separated parts. Simple assembly is required before use:
① Insert the battery pack into main body as picture shows.
You will hear a click sound when fitted.
② tConnect he tube to the main body.
Connect the floor brush to the tube.③

Lithium Battery Charging
The battery needs to be charged when the indicator lights twinkle. The lights keep
twinkling in circles while charging and turn to a complete circle while fully charged.
Attention: Please use original charger or the lithium battery can be damaged.
Start/stop working and switch speed
Press the touch panel to switch speeds. The RED light means the highest speed in active
and the BLUE light shows the eco speed in active.
Press the ON/OFF button to start and stop the machine.

Dust cup cleaning and maintenance
Method 1: Press the dust drop button and empty the dust into a rubbish bin.
Method 2: Press the dust cup release button and take out the dust cup from the main
body as the picture below.
Take off the HEPA filter and cyclone cone, empty all the rubbish and clean it. Install them
back as the picture below after the parts have air dried.
Attention: Do not use the machine before reinstalling the HEPA filter and cyclone cone or
it may damage the unit.

Floor brush cleaning and maintenance
① Press the roll brush release button.
② Take the roll brush out.
Wash the roll brush and air dry it. Fix it back as the pictures below.③
Reset the roll brush release button to the lock position.④
Motor rated voltage and rated power
Floor brush rated voltage and rated power
Lithium battery
Charger input
Charger output
Charging time
Noise
Rated continuous working time
Product size
Product net weight
22.2V 200W
22.2V 15W
22.2V 2200mAh
~100-240V 50/60Hz
~27V 0.5A
4-5 hours
≤70 dB
10 minutes at high speed
30 minutes at low speed
348*120*220mm(main body)
1.43kg(main body)

A new unit may become hot with a slight plastic odour after running the motor at high
speed for several minutes. This is normal and not a cause for concern.
Please note
Problem
Not working
Weak suction/
Trash drops
down from
tube
No LED light
is shown
when
charging
Not full
battery
after charging
Floor brush
not working
Possible causes Resolutions
● No power
● Brush protected or obstructed
● Charging
● Restart the machine
● Dust cup is full of rubbish
● HEPA filter is full of dust
● Floor brush or electrical tube
has been clogged by hair or
large pieces of rubbish
● Clean the dust cup’s rubbish
● Clean or change the HEPA filter
● Clean the floor brush or electrical
tube’s inner rubbish
● Battery pack is not installed in
right position
● The adaptor’s connector is not
inserted in the charging hole
● Install the battery pack in right
position
● Push the adaptor’s connector into
the charging hole in right position
● Charging time is not enough
● Battery is aging
● Charge for enough 4-5 hours
● Replace battery
● Large particles or objects
vacuumed
● Blanket resistant strength is too
hard and protected itself.
● The brush roll is entangled by
hair or wire.
● Clean the floor brush and restart
the machine
● Turn off the machine and take the
floor brush a little high of the
blankets leave some space
between floor brush and
blankets and restart and machine
● Clean the brush from hair, wire or
other things