Bonsai Zentrum 2419 User manual
Mini high-pressure cleaner 2419
Instruction for use
I. Introduction
This device is a sophisticated cleaning tool with excellent performance.
The water released at high pressure removes impurities thoroughly.
ll. Technical data
Voltage: 230 Volt
Fre uency: 50 Hz
Current: 0,4-0,6A
Power: 40W
Fuse: 800mA
Pressure: >0.8 MPa
Output uantity: 1-2 ml / s
Tank: 0,75 L
Cable length: approx. 2 m
Weight: approx. 1 kg
III. Use
Fill the tank with water and connect the unit to the power supply. Pressing and holding down the button (4) switches
the unit on.
The best distance for cleaning is about 10 to 15 cm between the target and the spray head. Spray the target
repeatedly until the dirt is removed.
The water pressure can be adjusted with the pressure regulator (8). On the angular additional nozzle there is an
additional adjustment lever for adjusting the jet cone.
IV. Safety instructions
•Only use with water!
•Always use safety glasses when using the unit.
•Never leave the unit unattended within the reach of children.
•During prolonged use, the unit will heat up and may be damaged. After 8 to 12 minutes of continuous use, a
pause is therefore re uired to allow the unit to cool down.
•This device is not a toy. Improper use may cause serious injury.
•Keep the tank sufficiently filled during operating so that the unit does not run dry.
•Never expose the unit to frost.
V. Maintenance
1.) Never operate the device without water!
2.) If the unit sounds normal, but does not release water or the pressure is lower than before, check the intake
manifold (22) for blockages. Unscrew the intake manifold, clean the strainer, screw it back on and try again.
3.) If the unit is running at low pressure or with an unstable volume, disconnect the unit from the power supply, open
the handle and check the pump screws. Replace them if necessary.
4.) If the unit sounds or sprays unfamiliarly, check and replace the spring (15) if necessary.
5.) Before prolonged non-use: empty the tank and allow the unit to spray for a few seconds without the tank to
ensure that any li uid remaining in the unit has been used up.
6.) From time to time, add some sewing machine oil to the opening provided on top of the machine.
7.) This article is not intended for use on persons or animals. Please keep the unit out of the reach of children.
The device
1.
2.
3.
3A.
4.
6.
7.
8.
9.
10.
11.
12.
Housing
Housing cover
Drive unit
Vibration mechanism
Start button
Power cord
Buffer section
Pressure regulator
Brake spring (for 8)
Transducer for water tank
Adjusting roller
Adjusting roller spring
13.
14.
15.
16.
17.
18.
19.
20.
21.
22.
23.
24.
Pump cylinder
Piston
Piston spring
Intermediate push rod
Output valve plug
Output valve spring
Output head
Jet
Water tank
Intake pipe with strainer
Locking screw
Fuse
ngled additional nozzle
with adjustment lever for adjusting the jet
Bonsai-Zentrum Münsterland GmbH · Raiffeisenstraße 22 · 59387 Ascheberg
0049 2593 / 95 87 14 · in[email protected] · www.bonsai.de
