bouncepad Floorstanding with Brother Printer Mount User manual

Sheet Code: BP-IM-057_REV1
Release Date: 09/01/2020
Copyright 2016 Spotspot Ltd. (T/A
Bouncepad) all rights reserved.
Condential, no part of this publication
may be reproduced or transmitted in any
form without the written permission of the
copyright holder.
Brother Printer Mount
Floorstanding with
Brother Printer Mount
Assembly Instructions
Tools Required:
Socket Driver
4x M3x10mm
Buttonhead
screw
1x T10 Pin Torx
Allen Key
10mm Spanner *or adjustable spanner Fixings Kit
Faceplate
Tablet Set-up Kit
Case
Floorstanding
Rubber Collar
Floorstanding Base
Floorstanding
Pole
Floorstanding Cover
Pair of Keys
In the Box (Floorstanding)
In the Box
(Printer Mount)
4x M6x25mm
Countersunk
screw
4x M4x20mm
Buttonhead
screw
1x T20 Pin
Torx Driver Bit
1x PZ3 Pozi
Driver Bit
4x M6
Locking Nut
4x M4 Split
Washer
4x M6 Split
Washer
1x Case
Washer
Fixings List (Floorstanding)
* Due to the modular nature of our product range
you may receive additional xings in the xings kit
Orientate, locate and secure the Floorstanding
Pole to the Floorstanding Base as shown. Ensure
that all xings are installed correctly.
Locate the Floorstanding
Cover over the
Floorstanding Pole.
1 2
Tighten screw(s) using hand tools, using electric
tools may damage your Bouncepad.
M6 Nylon Locking nut
M6x25mm
Countersunk
screw
M6 Split Washer
Fixings List
(Printer Mount)
Remove Neck-Ring using
T20 driver bit and Socket
Driver
3Feed the printer’s power cable through the Floorstanding Pole 4Attach the printer to
the Printer Mount using
M3x10mm Screws
5
T20 Pin Torx Driver Bit
M3x10mm
Buttonhead
screw
T10 Pin Torx
Allen Key
*designed for Brother QL-820WNB
*Printer is not provided.

Feed the tablet power cable through
the Case & Floorstanding Pole.
11
Locate and secure the Case onto the
Mounting Arm as shown. Tighten by
hand.
9
Case Washer
M4x20mm Button head screw
M4 Split Washer
T20 Pin Torx Driver Bit
Tighten screw(s) using hand tools, using electric
tools may damage your Bouncepad.
4x Corner Pieces
1x Cable Clip
4x Tablet Supports
12 Install the Tablet Setup Kit. Each kit is
specic per device & case.
Install the tablet into the Case &
connect to power.
13
Feed power cable through Printer
Mount and plug into Printer
6 7 Re-attach Neck-Ring Pull cable back to remove any slack
near the Printer Mount
8
Unlock & remove the Faceplate from
the Bouncepad Case.
10
14 Locate and lock the Faceplate to the
Case.

15.1 15.2 16
Connect the tablet power cable to its
mains power source.
If installing a battery pack, connect
the tablet cable and locate the pack
into the Floorstanding Base.
With the Floorstanding Cover on
the ground, locate and t the
Floorstanding Rubber Collar.
*designed to support the Anker PowerCore 10000mAh.
*battery pack is not provided.
17 Installation is now
complete.
*We recommend recording the key number so
you can purchase additional keys in the future.
Key number here