bouncepad VESA User manual

VESA
Assembly Instructions
Follow these instructions for
the successful assembly of your
Bouncepad VESA.
Sheet Code: BP-OR-IM-017_REV2
Release Date: 17/07/2018
Copyright 2017 Spotspot Ltd. (T/A
Bouncepad) all rights reserved.
Condential, no part of this publication
may be reproduced or transmitted in any
form without the written permission of the
copyright holder.
Fixings KitTablet Set-up Kit
Faceplate Case
VESA Mount
VESA - In the Box
0
Tools if
mounting to
a VESA arm
0B
Position & mark the mounting surface
on which the Bouncepad VESA is to
be located. Ensure the VESA is level.
1A Drill the xing holes in your surface.
Refer to your chosen xings for the
appropriate hole depth & diameter.
2A Secure the Bouncepad VESA mount to
the mounting surface.
3A
Attach the Bouncepad Case to the
Mounting Arm. Take care to ensure
correct & full thread engagement.
4A Install the Tablet Setup Kit. Each
kit is specic per tablet device and
Bouncepad Case.
5A
Tools if mounting to a
surface
0A
Socket
Driver
Drill
Drillbit
Ø 4.0mm
If fixing from behind:
Ø Determined by
your chosen xings.
If fixing from front:
*xings to mounting surface not provided
Socket
Driver
*M4 xings to VESA arm
not provided
T20 Driverbit
M4 Button-head screw
M4 Split Washer
Case Washer
4x Corner Pieces1x Cable Clip
4x Tablet Supports
Feed the tablet cable through the
Case. Connect it to its power supply.
Install your tablet into the case.
6A

Feed the tablet cable through the
Case. Connect it to its power supply.
Install your tablet into the case.
4B
Locate and lock the Faceplate onto
the Bouncepad Case. We recommend
recording the Bouncepad key number
8A
Locate & lock the Faceplate onto the
Bouncepad Case. We recommend
recording the Bouncepad key number.
5B
Secure the Bouncepad VESA mount to
VESA mounting bracket
1B
* Bouncepad VESA to third party VESA mount xings
not provided. Image shown for illustrative purposes &
may bare zero resemblance to xings specied for your
VESA mount. Refer to specications provided by the
third party VESA mount for the recommended xings.
*Bouncepad VESA mount is compatible with 75x75mm
and 100x100mm VESA mounting congurations.
* we recommend holding the Tablet within the
Bouncepad Case during application and removal of the
Faceplate.
* we recommend holding the Tablet within the
Bouncepad Case during application and removal of the
Faceplate.
T20 Driverbit
M4 Button-head screw
M4 Split Washer
Case Washer
2B Attach the Bouncepad Case to the
Mounting Arm. Take care to ensure
correct & full thread engagement.
3B Install the Tablet Setup Kit. Each
kit is specic per tablet device and
Bouncepad Case.
4x Corner Pieces1x Cable Clip
4x Tablet Supports