bouncepad Wing-Slim User manual

Sheet Code: BP-IM-071_REV0
Release Date: 24/05/2021
Copyright 2016 Spotspot Ltd. (T/A
Bouncepad) all rights reserved.
Condential, no part of this publication
may be reproduced or transmitted in any
form without the written permission of the
copyright holder.
Wing - Slim
Assembly Instructions
In the Box Fixings
List
Tools Required:
All tools provided
Mounting Arm
Access Panel
Mounting
Bracket
Mounting Arm
Case Back Faceplate
2x M4x10mm
Buttonhead
screw
10x M6x10mm
Buttonhead
screw
*xings to attach the stand to the
ground are not provided.
Position the Mount Bracket on the
ground where the stand is to be
located.
1
If using a hard-wired power supply,
feed the cable into the Mounting
Arm.
56Locate the Mounting Arm onto the
Mount Bracket as shown.
Minimum:
or
380mm 15”
2Mark your mounting surface, then
drill (as appropriate to your chosen
xing method).
*xings to attach the
product to the ground
are not provided.
3
4
Secure the Mount Bracket to your
mounting surface, with your chosen
xing method.
Remove the Access Panel from the
Mounting Arm. Store all parts safely
aside for use later.
*shown for illustrative purposes.

12
13 14
Locate and lock the Faceplate onto the Case
Back. For additional security, install 2x M4x10mm
screws to retain the Faceplate.
Locate and secure the
Access Panel to the
Mounting Arm.
For additional security, the stand has
multiple Kensington Security Slots.
Where required, install the cable.
8 9
10 11
Unlock and remove the Faceplate
from the Case Back. Store this aside.
Locate and secure the Case Back to
the Mounting Arm, with 4x M6x10mm
screws. Ensure good Case alignment.
Install the tablet and the
tablet power cable. Connect the tablet to a power source.
Installation is now complete.
15
*The Case is congured to your order.
If requiring a dierent tablet
conguration, please contact us.
7Secure the Mounting Arm to the
Mount Bracket, with 5x M6x10mm
screws.