Brother BE-1204B Owner's manual

3/10/05 1
With the power to the machine OFF.
1. Remove the tubular attachment. This will vary
depending on your machine model.
BE-1204B/BE1206B – Loosen the pair of
black thumbscrews on the pantograph that
hold on each the tubular arms. Slide the
thumbscrews toward the center of the
tubular arms and them remove the arms.
BE-1204C -
Remove the pair of black
thumbscrews on the pantograph that hold
on each the tubular arm and remove each
tubular attachment.
3. Lift up on the cap frame sash so that the
positioning pins fit into the oval holes and lower
on to the pantograph.
2. Remove the two black thumbscrews from the cap
frame assembly. Then slide the cap driver onto the
machine. Each cap assembley is labeled as to what
head it goes on.
4. Hold the fixed lever as shown and insert in to the
hole underneath the pantograph. Push up and
toward the inside until it stops. Then lock the fixed
lever by pushing down. Do this to the other side.
For Technical Assistance Please Call Toll Free 1-877-4BROTHER
Email: [e-mail]
Website: http://www.brother-usa.com/industembroidery/tech_down.aspx
B
BE E- -1 12 20 04 4, , 1 12 20 06 6
Positioning Pin

3/10/05 2
5. Here is what the fixed driving lever should look
like when installed.
6. Install the black thumbscrews on to the pantograph.
Adjust centering of cap frame assembly left to right
before tightening thumbscrews.
6. Flip mode switch on machine to CAP. Turn power
ON.
B
BE E- -1 12 20 04 4, , 1 12 20 06 6
For Technical Assistance Please Call Toll Free 1-877-4BROTHER
Email: [e-mail]
Website: http://www.brother-usa.com/industembroidery/tech_down.aspx