BRUMATE BruTank 55qt User manual

BrüTankTM 55qt
Made For This Made For This Made For This Made For This Made For This Made For This Made For This Made For This Made For This
Ice temperatures vary slightly
Warm ice (around 32*F) is typically wet or dripping and won’t
last long. Ice that is colder than freezing point is relatively dry
and will last substantially longer.
Air and sunlight are the enemy
Large areas of air inside your cooler will accelerate ice melt as
the ice is consumed with having to cool the air, instead of your
contents. If you do need to leave space in your cooler, they are
best filled with extra ice or beverages. Keeping the cooler out
of direct sunlight will also maximize ice retention.
Don’t drain the water
Do not empty the cold water from the melted ice. The water
helps to insulate the remaining ice.
Rock salt is your friend
Using rock salt will super-chill your contents. Simply sprinkle
rock salt on top of the ice, close your cooler and enjoy extra
cold drinks.
Start with a chilled cooler and
chilled beverages
If the beverages you are putting into the BrüTank start out warm,
a significant amount of ice will be wasted cooling the cooler itself.
Preload your cooler a few hours prior to use with a sacrificial bag
of ice to cool it down or store it in a cool place before loading it up.
Ice Retention How to Insert the Tank
Slide the tank into the cooler and ensure it is seated securely.
ProTip: You can also use the cooler without the tank to increase
ice capacity.
Tips + Tricks
Once the tank has been installed, insert the tap
from the outside and hand-tighten until the tap
is facing vertically. Do not over-tighten.
01
03 When removing the tank simply unscrew the tap
and lift the tank out of the cooler and witness the
magic of our self-tapping tank at work.
02
To use the tap, press the button, and it will
activate the internal tap allowing liquid to flow
freely. When not in use, use the included spout
cover to keep it clean.

BrüTankTM 55qt
Made For This Made For This Made For This Made For This Made For This Made For This Made For This Made For This Made For This
Tips + Tricks
Removing the Tank LidHow to Drain the Cooler
Loosen and pull out the drain plug until the stopper is engaged.
Tilt the cooler at an angle to ensure you drain the cooler completely.
Turning the dial on the lid allows the cooler to vent ensuring your
drinks flow smoothly.
How to Vent the Drink Tank
vented not vented
Cleaning Instructions
Unscrew the tap or plug and remove the tank
01
02 Clean the tank and cooler with a mild dish
detergent and hot water
03 Rinse the tap thoroughly with hot, soapy water
and allow all components to dry completely
04 Ensure components are tightly fastened before
use to prevent leakage
ProTip: After use, clean your BrüTank
with a mixture of mild soap and warm
water. Make sure to remove the drink
tank after each use to ensure no
moisture gets trapped underneath,
and clean other areas prone to debris
collection like the drain plug and lid
gasket. Completely dry your BrüTank
before storing with the lid closed.
Pull up on the hinged
closure to remove lid.