CertainTeed Beaumont II User manual

Beaumont II - Parts List
Qty. Description
4
4
2
8
4
4" Knuckle
4" Keystone Halves
31 7/8" x 48" Lattice Panel
1 1/2" x 1 1/2" x 31 7/8" Cross Member
4" x 4" x 78" Arbor Post
290° Arch - Male/Male
290° Arch - Male/Female
41 1/2" x 1 1/2" x 31 7/8" Cross Member (With notched ends)
- All parts made in the USA-
CertainTeed Fence, Railing, Deck
231 Ship Canal Parkway
Buffalo, NY 14218
1.800.333.0569
www.certainteed.com
Beaumont II - 70320

Step 1
Step 3
Repeat this process for the second arch. They
should look as shown above.
Lay one (1) Arbor Post onto a clean soft surface and slide the Lattice Panel into the long slot starting at
one end until it is completely in place. Insert two (2) 1 1/2" x 1 1/2" Cross Members (with notches) into the
square holes at the top and bottom of the Arbor Post. Make sure that the non-notched side faces
the lattice.
Step 4
Step 2
Assembly Instructions
Step 5
Notch
Notch
Slide one of the Male/Male Arch sections into a
Female/Male section until they are flush.
Align the pegs on the keystone with the
four mating holes on the arch. Push until it is
flush with the arch. Slide on another Keystone half
onto the arch and snap both halves together.
Insert (8) 1 1/2" x 1 1/2" Cross Members without
notches into one of the assembled Arches.
Place the second Arch assembly against the
opposite end of the Cross Members and install
them one at a time until both Arch halves are fully
together.

52"
28"
59"
Step 6
Attach another Arbor Post over the opposite side. Start from one end of the pannel and work to another.
Slide two (2) 4" Knuckles on the short ends of each of the Arbor Posts. 
Repeat this step to create another Arbor side.
Step 7
Dig four (4) holes approximately 10" round and
12" deep. The holes should be spaced apart as
shown in the diagram above.
Step 8
Place the assembled Side Panels into the holes. The
bottom edge of the lower Cross Member should be
13" from the ground with drain holes exposed.
Step 9
Install the Arch onto the top of the Arbor Posts
as shown above. (If desired, PVC glue can be
added to the inside of the Arbor Posts prior to
attaching the Arch.
Step 10
Fill the four holes with cement. Frequently
check that the finished Arbor is level in all directions.
13"
Drain Hole