Clarion AUTOMOTIVE INFRARED WH100 User manual

AUTOMOTIVE INFRARED
STEREO HEADPHONE SYSTEM
Owner’s Manual
Model: WH100
INTRODUCTION:
Congratulations on your purchase of a sophisticated, high-
tech ClarionAutomotive Infrared Stereo Headphone System.
This system frees you from the tangle of Headphone wires
and lets you enjoy music or TV without the tangle of cables
around you. To ensure the best performance of your system,
please read this manual carefully.
SPECIAL FEATURES:
nAutomatic Level Control prevents input signal over
loading.
nUses high frequency infrared light to assure a clean sig-
nal for clear reception.
nAdjustable Headphone band.
EXPLANATION OF CONTROLS: (Fig. 1)
Infrared Transmitter:
1. Infrared Emitting Leds - Transmit signal to headphones
Headphone Receivers:
2. Infrared Sensors - Receive signal from the transmitter
3. Battery Cover
4. Volume Control
5. Power Switch
6. Power Indicator Led
7. Auto ON/OFF Micro Switch Fig. 1
BATTERY INSTALLATION: (Fig. 2)
1. Place two (2) alkaline AAA batteries into the battery com-
partment of the Headphones, making sure that the battery
polarity is correct.
OPERATION:
Please read carefully to prevent damage to the Headphones
or your ears.
1. Be sure batteries are properly installed in the
Headphones.
2. Turn the Headphone volume nearly off before turning on
the power. Turn on the Headphone power then adjust the
Headphone volume louder to a comfortable level. (You
can adjust the audio source volume louder if needed).
Fig. 2
Auto ON/OFF Switch is
activated when headphones
are placed on head.
Warning: Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a resi-
dential installation. This equipment generates, uses and can radiate radio fre-
quency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or televi-
sion reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct interference by one or more of the following
measures:
nReorient or relocate the receiving antenna.
nIncrease the separation between the equipment and receiver.
nConnect the equipment into an outlet on a circuit different from that to which
the receiver is needed.
nConsult the dealer or an experienced radio/TV technician for help.
Clarion Sales Corporation, 661 West Redondo Beach Blvd.
Gardena, CA90247-4201 Phone: [phone] FAX: [phone]
Clarion Canada, Inc., 2239 Winston Park Drive, Oakville,
Ontario L6H 5R1, Canada Phone: [phone] FAX: [phone]

Part No. OMWH100
1. GROUND
2. WHITE
3. RED
4. BLACK
5.RED
LEFT CHANNNEL INPUT
(200mv to 500mv MAX.)
RIGHT CHANNNEL INPUT
GROUND
+12V IGNITION
WIRING DIAGRAM
TOP VIEW
TRANSMITTER POSITIONING DIAGRAM
SIDE VIEW
IN-CAR TRANSMITTER
HEADLINER OF CAR
FACE LEDs TOWARD REAR OF VEHICLE
TRANSMITTER
POSITION IN MIDDLE
OF SEATING AREA
TRANSMITTER
POSITION JUST ABOVE THIGH AREA
OF SECOND PASSENGER ROW SEATING