NO TOOLS
REQUIRED LINE DRY
Installation
1. Identify the front of your Golf Car enclosure by locating the interior
yellow tag which reads "FRONT". Drape the enclosure over the roof of
your golf car with the zippered panel at the back.
2. Pull the cover from front to back onto the roof. Make sure the roof
edges line up with the seams.
3. Zip the side and rear panels down over the car.
4. Attach the elastic hooked straps along the sides of the golf car.
See figure 1.
5. The side doors open with zippers. To keep the doors open fold in half
and snap secure. Roll the doors to the back and fasten them with the
provided rip-and-grip straps. See figure 2.
6. If your enclosure has removable doors (all but the travel enclosure),
hold zipper and door and firmly pull horizontally apart as shown in
figure 3.
7. There is a zippered opening in the back so you can easily load and
unload your golf clubs. If your enclosure has a zippered rear panel it
can be rolled all the way up to the roof and secured with rip-and-grip
straps. The Yamaha®, E-Z-GO®, & Club Car Precedent®model specific
enclosures can be secured at the halfway point as well.
8. If your enclosure has a removeable windshield you can completely
unzip the windshield. The Yamaha®, E-Z-GO®, & Club Car Precedent®
model specific enclosures have a front hideaway pocket where you can
store your windshield when not in use. See figure 4.
Cleanning
Clean your enclosure with a soft brush and lukewarm water. DO NOT USE
SOAP as it may remove the protective coatings. Line dry.
Tip: If the clear vinyl windows on your cover are wrinkled from storage
you can smooth them out with a hair dryer. Be sure to set the dryer on
low and hold it at an appropriate distance.
Tip: Clean clear vinyl windows with mild soap using your hands or a soft
cloth to avoid scratching the surface.
1
2
3
4
Rear zippered entry for golf clubs works well
with rear canopies
Driver and passenger doors can be rolled to the
side and held open with straps (doors are shown
closed in this photo)
Each side zips for easy door entry and exit
Hooked straps along each side secure
cover to car for a custom t
WARNING
Make sure your enclosure is on properly and
securely fastened before operating your golf car.
WARNING
Enclosures do NOT protect against noise, engine
exhaust, chemicals, collision, roll-over or other
accidents.
WARNING
When your golf car is at idle with your enclosure
installed, make sure to open a side door to ensure
proper ventilation against carbon monoxide.
Storage
A handy storage bag is
provided to store your
enclosure in. To avoid
mildew, be sure the
enclosue is completely
dry before you store it in
the storage bag.
