Clint Odin-Foot User manual

ENGLISH

BEFORE ASSEMBLY
This is what is in the box and what you will
need to assemble the foot for ODIN
• 1 x Top piece
• 1 x Bottom piece
• 2 x Screws
• 5 x Rubber pads
• 1 x Instruction manual
1 x Philips head screwdriver
1 x Cloth to avoid scratching (Optional)
Note: After unpacking all above
items from the box, make sure
everything is present and ready
to be assembled.
In the box:
What you need:

FOOT ASSEMBLY
These are the steps to
assemble the foot for ODIN
1. Place the bottom piece on a at
surface.
2. Take the top piece and slide it
into the bottom piece so the screw
holes align. - See below picture.
3. Take the screwdriver and the two
screws. Screw both screws rmly in
either side to fasten the two piece
together. - See below picture.
Note: It is always a good idea to
occasionally tighten the screws to
make sure that the foot is as sturdy
as possible.
FOOT ASSEMBLY
These are the steps to
assemble the foot for ODIN

ADDING RUBBER PADS
Adding the included rubber pad
to the ODIN foot.
1. Place the ODIN foot upside down
on a cloth. Make sure to do this on
a at surface.
2. Take the 5 rubber pads and
remove the stickers that protects
the adhesive sides.
3. Place the rubber pads carefully in
the holes as shown in the illustration.
4. You can now turn the ODIN foot
around and place ODIN speaker on
top. Make sure the bottom of ODIN
matches correctly with top of the foot.
5. Turn on your speaker and enjoy!
PLACING ODIN IN FOOT
Last step is to place ODIN
correctly on the foot.
Note: Placing ODIN with the foot in
a corner of a large room gives the
best possible sound performance.