
Copyright © 2016 Cnoc Outdoors. All Rights Reserved
Reverse the deployment process:
1. Release the lock handle for the size adjuster
2. Fit the top shaft all the way back in
3. Lock the length adjuster
4. Press the metal pin and fit the hidden shaft in again
5. Pull apart all the sections
6. Wrap the holding strap around the pole
Vertex poles were designed specifically to allow for easy maintenance as dirt, dust and moisture are
the main reason most of poles break or get stuck over time.
The best way to maintain your poles:
1. When back from a trip, open the poles and release all the sections
2. Open the lock handle and slip out the size adjusting shaft
3. Wash the handle with water and if very grimy, with some plain soap
4. Remove the basket and rubber tip from the bottom and wash with water
5. If the poles are very muddy/dusty/wet wash each shaft with water only
6. Let all the parts dry in open air until fully dry
7. Reassemble pole
All our products come with a 1 year warranty against defects in materials or workmanship. If
anything is found to be defective against this warranty then we will repair or replace it at our
discretion. Normal wear and tear, misuse, alteration or abuse is not covered.
Registered products enjoy an extended warranty against purchase reference, giving you 2 years of
warranty against defects in materials or workmanship from the date of purchase. Just register to
enjoy.