cocoweb Canberra Nautical User manual

CAUTION Please read this entire manual before installation and use of fixture.
IMPORTANT - Observe all local governing codes and ordinances.
IMPORTANT - Save these instructions for later use.
Installation of lights and electrical work may present a possible shock or fire hazard if improperly installed or used. All
electrical work should be performed in accordance with all federal, state and local safety regulations and require proper
grounding. All work should be performed by a certified electrician. Before starting installation, turn OFF electricity at the
main fuse or circuit breaker that controls the power to the fixture/room you are working on.
Congratulations on purchasing your new quality lighting fixture from Cocoweb.com. If you have any questions about these
instructions or are missing any parts, please call us at 888-783-0378 or visit our website at www.cocoweb.com.
COCOWEB LIMITED WARRANTY:
Cocoweb.com warrants its products to be made of first class materials, free from defects of material or workmanship under
normal use and to perform the service for which they are intended in a reliable and efficient manner when properly installed,
for a period of two years from the date of purchase. During the warranty period, Cocoweb.com will, at its choice, repair or
replace any part or parts which prove to be defective if returned to Cocoweb.com. NOTE: Modification of product in any way
will void the warranty.
CARE INSTRUCTIONS:
DO NOT use abrasive or chemical cleaners to clean the light as it may damage the finish. Use only warm water, then wipe
dry with a clean soft cloth.
TROUBLESHOOTING AND REPAIR:
Check for damaged or worn parts before installation. Broken or damaged parts will affect the products operation. Replace or
repair damaged or worn parts immediately. Should the light stop working properly and/or one of the following problems
occur: (1) The lamp fails to turn on (2) The lamp flickers (3) The lamp dims to an unusual level, check all connections and
then turn the lamp back on. If the problem persists, disconnect the lamp and contact Cocoweb customer service.
IMPORTANT SAFETY INSTRUCTIONS:
• Do not use with damaged electrical cords.
• Never overload electrical circuits as it may cause electrical shock or fire.
• Do not look directly into the light source.
Rev. 2 (07/17)
WARNING
Keep children away from packaging
cocoweb.com
The information in this document is subject to change without notice.
COPYRIGHT ©COCOWEB.COM 2017
COCOWEB.COM
13715 Alton Pkwy
Irvine, CA 92618
Phone: [phone]
INSTALLATION INSTRUCTIONS
CANBERRA NAUTICAL BULKHEAD LIGHT

INSTALLATION GUIDE:
1. Unscrew the wing nuts by turning counter
clockwise and remove the glass.
2.Make sure the power cable is threaded through
the bottom of the fixture.
3. Insert Bulb and tighten clockwise until it is
securely fastened.
4.Make sure the water proof aprons are fixed to
the base.
5. Replace glass then screw in the wing nuts
clockwise.
Installation of lights and electrical work may present a possible shock or fire hazard if improperly installed or used. All
electrical work should be performed in accordance with all federal, state and local safety regulations and require proper
grounding. All work should be performed by a certified electrician. Before starting installation, turn OFF electricity at the
main fuse or circuit breaker that controls the power to the fixture/room you are working on.
Rev. 2 (07/17)
WARNING
CANBERRA NAUTICAL BULKHEAD LIGHT
INSTALLATION INSTRUCTIONS
WIRING INSTRUCTIONS:
1. Strip power cord to desired length.
2. Connect the WHITE (Neutral) wire from the accessory to the
WHITE (Neutral) wire from the junction box.
3. Connect the BLACK (Live) wire from the accessory to the
BLACK (Live) wire from the junction box.
Keep children away from packaging
cocoweb.com
The information in this document is subject to change without notice.
COPYRIGHT ©COCOWEB.COM 2017
COCOWEB.COM
13715 Alton Pkwy
Irvine, CA 92618
7.1