Columbia Products 605FL User manual

1
Operating Manual for Wall Mounted Sinks
Models 605FL, 605FL-1.0 and 605FL-0.5
Columbia does not recommend use with harsh chemicals.
NSF/ANSI Standard 2 - Food Equipment and NSF/ANSI 372 low-lead.
WALL MOUNTED SINKS

2
COLUMBIA SPECIFICATIONS
1622 Browning Irvine, CA 92606-4809 Phone: [phone] Toll Free: 800.626.2117 Fax: [phone] www.columbiasinks.com email: [e-mail]
©2016 Columbia Products
Installation Instructions
Step 1
1. Establish sink location on the wall.
2. Measure a recommended 41.5” from finished floor and draw a level line which will be the top
edge of the wall mounting bracket.
3. Hold the wall mounting bracket against the wall and mark the wall where the holes are. Drill holes
and secure bracket to the wall as shown in illustration A. Screws are not provided.
Step 2
1. Install faucet assembly to the sink.
2. Install strainer assembly at the drain hole.
3. Connect hot and cold water supply (not included) to the faucet.
Step 3
1. Position the sink onto wall bracket.
2. Mark holes for fastening side mounting brackets as shown in illustration B.
3. Remove sink from the wall bracket.
4. Drill holes in wall for securing sink to wall.
5. Hang sink on the wall bracket and secure to the wall.
Step 4
1. Connect waste line or drain pipe to the strainer assembly.
2. Connect hot and cold water supply lines to the water source.
3. Remove aerator from the spout and flush water system.
4. Check connections for leaks.
5. Replace aerator onto the spout.
Parts List
(1) Wall mount sink
(1) 8” on center faucet
(1) Faucet mounting kit
(1) Wall-mounting bracket
(2) Support brackets
(1) Strainer assembly with basket
Tools Required
Tape Measure
Adjustable Wrench
Drill Motor and Drill Bits
Pipe Wrench
Level
Safety Glasses
Screw Drivers: 1 Phillips & 1 Standard
Pencil
Socket Wrench
WALL MOUNTED SINKS
Illustration A
Illustration B

3
COLUMBIA SPECIFICATIONS
1622 Browning Irvine, CA 92606-4809 Phone: [phone] Toll Free: 800.626.2117 Fax: [phone] www.columbiasinks.com email: [e-mail]
©2016 Columbia Products
13”
(330mm)
45º
605F
6”
(152mm) 6” (152mm)
4”
(102mm)
4” (102 mm)
16” (406mm)
14.875” (378mm)
6.125” (156mm)
14” (356mm)
2” drain hole
Stainless Steel Brackets
8” (127mm)
5” (203mm)
1.25” R
32mm
Hole Configurations
Front Side
Top
wall hanger
4.5”
(114.3mm)
8” (127mm)
.875” (22mm)
dia. hole
5.5” (140 mm)
15.25”
(387.35mm)
11”
(279mm)
2” (51mm)
Models 605F and 6054
21.75”
(552mm)
7.5” (191mm)
WALL MOUNTED SINKS