Columbia Products SANI-LAV 521FL User manual

1
FLOOR MOUNTED SINKS
Operating Manual for Floor Mounted Sinks
Model 521FL
Columbia does not recommend use with harsh chemicals.
NSF/ANSI Standard 2 - Food Equipment and NSF/ANSI 372 low-lead.

2
FLOOR MOUNTED SINKS
COLUMBIA SPECIFICATIONS MODEL 521FL
1622 Browning Irvine, CA 92606-4809 Phone: [phone] Toll Free: 800.626.2117 Fax: [phone] www.columbiasinks.com email: [e-mail]
©2013 Columbia Products
Tools Required
Tape Measure
Adjustable Wrench
Drill Motor and Drill Bits
Pipe Wrench
Level
Safety Glasses
Screw Drivers: 1 Phillips & 1 Standard
Pencil
Socket Wrench
Installation Instructions
Step 1
1. Attach bowl to pedestal base by slipping bolts on bowl through openings on pedestal base as
shown in illustration A.
2. Tighten the 6 nuts to the threaded bolts under bowl. Do not over-tighten. There are 6 bolts that
will securely hold the bowl in place.
Step 2
1. Place the sink at the desired location.
2. Mark the floor where the four holes are at the pedestal base as shown in illustration B.
3. Drill holes as required for mounting hardware. (Hardware not included)
Step 3
1. Install strainer assembly using plumbers putty to seal the strainer to sink.
2. Install faucet assembly to the sink back-splash.
3. Install hot and cold water lines to the back of the faucet. (not provided)
Step 4
1. Mount pedestal sink to the floor.
2. Connect waste line or drain pipe to strainer assembly. (not provided)
3. Connect hot and cold water supplies lines to the water source. (not provided)
Step 5
1. Turn water on.
2. Remove aerator from the spout and flush water system.
3. Check connections for leaks.
4. Replace aerator onto the spout.
Parts List
(1) Sink bowl – Model 521FL
(1) Pedestal base
(1) Set of 6 mounting nuts to attach bowl to pedestal base
(1) Chrome-plated faucet with a 10” swivel spout and 4” wing levers (8” on center) – Model 2004
(1) Faucet mounting kit - Model SMK
(1) Strainer assembly with basket – Model 1010
Trouble Shooting Guide
Problem Possible Cause To Diagnose Remedy
Water drips from the
spout or from under
the lever.
1. Seat washer is worn
2. Seat is worn
3. O-rings are worn
Shut cold water source off. See if water still leaks from the spout.
If leaks continues repair hot side if not repair cold side.
Recommend installing hot or cold
faucet repair kit.
Illustration A
Illustration B

3
COLUMBIA SPECIFICATIONS MODEL 521FL
1622 Browning Irvine, CA 92606-4809 Phone: [phone] Toll Free: 800.626.2117 Fax: [phone] www.columbiasinks.com email: [e-mail]
©2013 Columbia Products
FAUCET REPLACEMENT PARTS
G
I
K
M
P
O
N
Q
Q
D
DB
E
F
A
C
Q
H
J
L
M
2
2
3
3
4
4
5
5
1
1
6
6
Part No. Decription Quantity Universal Part
A
2004-1 Faucet Body Assembly 1 YES
B
1062-C Faucet Valve Repair Kit - Cold 1 NO
C
1062-H Faucet Valve Repair Kit - Hot 1 NO
D
2004-2 Female Wall Flange Assembly 2 YES
E
2004-3A Bonnet Nut - Cold 1 NO
F
2004-4A Bonnet Nut - Hot 1 NO
G
2010-1 Handle 6” inch - Cold 1 NO
H
2010-2 Handle 6” inch - Hot 1 NO
I
2011-1 Handle 4” inch - Cold 1 NO
J
2011-2 Handle 4” inch - Hot 1 NO
K
2012-1 Handle 2.5” inch - Cold 1 NO
L
2012-2 Handle 2.5” inch - Hot 1 NO
M
2004-5 10-24 Oval Csk Screw x .5” 2 YES
N
2003-1 Swivel spout Assembly 1 YES
O
2001-1 12” swivel spout Assembly 1 YES
P
2002-1 6” swivel spout Assembly 1 YES
Q
1002 55/64 – 27 Female aerator 1 YES
Part No. Decription Quantity Universal Part
B
1062-C Faucet Valve Repair Kit - Cold NO
1Seat 1 YES
2Seat Washer Screw 1 YES
3Seat Washer 1 YES
4O-ring 1 YES
5Valve Stem 1 NO
6Bonnet Nut Washer 1 YES
C
1062-H Faucet Valve Repair Kit - Hot NO
1Seat 1 YES
2Seat Washer Screw 1 YES
3Seat Washer 1 YES
4O-ring 1 YES
5Valve Stem 1 NO
6Bonnet Nut Washer 1 YES
Replacement Parts

4
FLOOR MOUNTED SINKS
COLUMBIA SPECIFICATIONS MODEL 521FL
1622 Browning Irvine, CA 92606-4809 Phone: [phone] Toll Free: 800.626.2117 Fax: [phone] www.columbiasinks.com email: [e-mail]
©2013 Columbia Products
6.5”
(165mm) 6.5” (165mm)
8”
(203mm)
.875” (22mm)
dia. hole
6” (152mm)
9.5” (241mm)
19.5”
(495mm)
24”
(610mm)
45º
521F
9.5”
(241mm)
10”
(254mm)
22” (559mm)
1.25” R
32mm
Hole Configurations
Front Side
Top
6.5” (165 mm)
21” (533mm)
19” (483mm)
2” drain hole
20”
(508mm)
16”
(406mm)
2” (51mm)
7.5” (191mm)