Columbia Products SANI-LAV 512FFL Series User manual

FLOOR MOUNTED WASH STATIONS
Operating Manual for Six-Person Floor Mounted Wash Stations
Models 512FFL, 512FFL-1.0 and 512FFL-0.5
1
Columbia does not recommend use with harsh chemicals.
NSF/ANSI Standard 2 - Food Equipment and NSF/ANSI 372 low-lead.

COLUMBIA SPECIFICATIONS
©2016 Columbia Products
FLOOR MOUNTED WASH STATIONS 2
1622 Browning Irvine, CA 92606-4809 Phone: [phone] Toll Free: 800.626.2117 Fax: [phone] www.columbiasinks.com email: [e-mail]
Installation Instructions
Step 1
1. Assemble legs for the 54 and 56 series. For series 58, 510 and 512 the legs are pre-
assembled.
2. Place wash station sink on the leg assembly. Secure legs to bowl with hardware provided.
3. Place Wash Station Sink at the desired location.
4. Mark the floor where the mounting holes are at the base of the legs. See illustration A.
5. Drill holes as required for mounting hardware. Hardware Not Included.
Step 2
1. Install Faucet to the sink using faucet mounting kit provided.
2. Install Strainer assembly to the drain hole.
3. Connect hot and cold water supply lines (not included) to the back of faucets.
Step 3
1. Position wash station sinks to pre-drilled holes and secure sink to the floor.
2. Connect waste line or drain pipe to the strainer assembly. Not included.
3. Connect water supply lines (Hot and Cold) to the water source. Not included.
4. Remove aerator from the spout and flush the water system.
5. Replace aerator to the spout.
6. Check for leaks and tighten connections if necessary.
Step 4
1. Seal gap between bowl and leg assembly as shown in illustration B.
2. When mounting against wall, it is recommended sealing the top of the backsplash to wall as
shown on illustration C.
Tools Required
Tape Measure
Adjustable Wrench
Drill Motor and Drill Bits
Pipe Wrench
Level
Safety Glasses
Screw Drivers: 1 Phillips & 1 Standard
Pencil
Socket Wrench
Trouble Shooting Guide
Problem Possible Cause To Diagnose Remedy
Water drips
from the spout
or from under
the lever.
1. Seat washer is worn
2. Seat is worn
3. O-rings are worn
Shut cold water source
off. See if water still leaks
from the spout. If leaks
continues repair hot side
if not repair cold side.
Recommend
installing hot
or cold faucet
repair kit.
Parts List
(1) Floor mount wash station
(1) Leg assembly set
(8) Washers and nuts for connection sink to leg assembly set
(6) 8” on center faucet
(6) Faucet mounting kit
(3) Strainer assembly with basket
Illustration A
Illustration B
Illustration C

7
9
11
13
22
21
20
19
18
17
16
25
25
25
15
24
24
24
14
23
23
23
4
42
5
6
1
3
8
10
12
13
B
B
C
C
D
D
E
E
A
A
F
F
COLUMBIA SPECIFICATIONS
©2016 Columbia Products
Part No. Decription Quantity Universal Part
12004-1 Faucet Body Assembly 1 YES
21062-C Faucet Valve Repair Kit - Cold 1 NO
31062-H Faucet Valve Repair Kit - Hot 1 NO
42004-2 Female Wall Flange Assembly 2 YES
52004-3A Bonnet Nut - Cold 1 NO
62004-4A Bonnet Nut - Hot 1 NO
72010-1 Handle 6” inch - Cold 1 NO
82010-2 Handle 6” inch - Hot 1 NO
92011-1 Handle 4” inch - Cold 1 NO
10 2011-2 Handle 4” inch - Hot 1 NO
11 2012-1 Handle 2.5” inch - Cold 1 NO
12 2012-2 Handle 2.5” inch - Hot 1 NO
13 2004-5 10-24 Oval Csk Screw x .5” 2 YES
14 2003-1 Swivel spout 2.0 GPM 1 YES
15 2003-1-1.0 Swivel spout 1.0 GPM 1 YES
16 2003-1-0.5 Swivel spout 0.5 GPM 1 YES
17 1001-1 Swivel spout 2.0 GPM 1 YES
18 1001-1-1.0 Swivel spout 1.0 GPM 1 YES
19 1001-1-0.5 Swivel spout 0.5 GPM 1 YES
20 2002 Swivel spout 2.0 GPM 1 YES
21 2002-1-1.0 Swivel spout 1.0 GPM 1 YES
22 2002-1-0.5 Swivel spout 0.5 GPM 1 YES
23 1002 Aerator 2.0 GPM 1 YES
24 1004 Aerator 1.0 GPM 1 YES
25 1003 Aerator 0.5 GPM 1 YES
Part No. Decription Quantity Universal Part
21062-C Faucet Valve Repair Kit - Cold YES
ASeat 1 YES
BSeat Washer Screw 1 YES
CSeat Washer 1 YES
DO-ring 1 YES
EValve Stem 1 NO
FBonnet Nut Washer 1 YES
31062-H Faucet Valve Repair Kit - Hot NO
ASeat 1 YES
BSeat Washer Screw 1 YES
CSeat Washer 1 YES
DO-ring 1 YES
EValve Stem 1 NO
FBonnet Nut Washer 1 YES
Replacement Parts
FAUCET REPLACEMENT PARTS 3
1622 Browning Irvine, CA 92606-4809 Phone: [phone] Toll Free: 800.626.2117 Fax: [phone] www.columbiasinks.com email: [e-mail]

COLUMBIA SPECIFICATIONS
©2016 Columbia Products
FLOOR MOUNTED WASH STATIONS 4
1622 Browning Irvine, CA 92606-4809 Phone: [phone] Toll Free: 800.626.2117 Fax: [phone] www.columbiasinks.com email: [e-mail]
1.5” (38mm)
15” (381mm)
10.5” (267mm)
.5” dia. floor
mounting holes
1.5” (38mm)
leg thickness
.75” (19mm)
from edge of leg
to first hole
512 Floor
10.25”
(267 mm)
120” (3048mm)
20” (508mm)20” (508mm) 40” (1016mm) 40” (1016mm)
117” (2972mm)
20”
(508mm)
2” drain hole
16.5”
(407mm)
10”
(254mm)
8” (203mm)
.25” R
6mm
.25” R
6mm
1.5” (38mm)
2” (51mm)
1.5” (38mm)
2” drain holes,(1.5” strainer)
.875” (22mm)
dia. holes (12)
Hole Configurations
Front
Side Leg Specifics
Top
7”
(178mm)
7”
(178mm)
8”
(203mm)
8”
(203mm)
8”
(203mm)
8”
(203mm)
10”
(254mm)
10”
(254mm)
8”
(203mm)
8”
(203mm)
10”
(254mm)
14”
(356mm)
14”
(356mm)
27” (686mm)
9” (229mm)
35” (889mm)
floor to rim
height
38” (965mm) 38” (965mm) 38” (965mm)
20” (508mm)
7.5” (191mm)
45º
2.875” (73.02mm)
.75” (20mm)
6.75” (171mm)