Comm Box MoCOW User manual

MoCOW
Moveable Stand
USER MANUAL

Warnings & SafetyInstructions
• Installation & assembly work must be carried out by properly licenced
techniciansor qualified trades people.
• Incorrect installation can cause the CBMOCOW-F unit to fall and cause injury. This
company assumes no responsibility for injuries or damages that may occur due to
improper installation andhandling.
• Theunitisdesignedforusewithspecificproductsandweight.Exceeding
maximum weight capacity to the moving frame may damage product and
equipment and could lead to serious personal injury.
• Adhering to proper installation instructions is critical in ensuring all components
functionproperly.Asmalldifferenceininstallationcanlead
to a severely skewed and
distorted projection image. In order to obtain a square image without the use of
digital adjustment of the projector, follow the step by step instructions as shown.
• Installation will require the lifting of heavy components. A minimum of two
people are required.
• Fullytightenallmountingscrews asspecifiedintheinstallation
instructions. However, attachment points can be damaged if a power drill
isused
totightenscrews.Screwsshouldbeturnedbyhandfirstbefore
tightening with a hex key.
Do not over tighten screws. Check fasteners regularly to avoid parts becoming
loose.
• Do not allow children to climb onto the frame.
• Make sure cables are not caught between moving parts to ensure cables will not
be damaged. Cable tie all loose cables to avoid damage.
• Ifapplicable,wentheCBMOCOW-Fisnotinuse,switchoffthepowersource.
• Make sure the fully raised height of the CBMOCOW-F does not exceed the height
of the building/room the CBMOCOW-F will be used in.

Package Contents
Two Carton
1Carton 1 for the Base, Frame,
and Accessories
2
Carton 2 for theColumn
Base to Column Fixing Kit Frame to
Column Fixing Kit Accessories
Fixing Kit
Base
Arms ×2

M
0
I
Specifications
/
. I
; .
0 .
I
_Q,
d
-i
U I L
·' 0
[ l
I I
'')q 0'
856,00 602,50
6
1441,50
F
([;I]

5
Installation – Attaching the Display
1. Tomountthedisplayonto theCBMOCOW-F
attach hook arms to the mounting
points at the back of the display. The lock of the
hook arms should be at the lower side of the
displayscreen.
NOTE: Make sure the hook arms are aligned
horizontally, or the picture will become
skewed.
2.
Hook the hook arms on the back of the display onto the frame of the
CBMOCOW-F (as shown). Adjust the screen horizontally along the crossbar
until it is in the desired position. When the display is in the desired
position, push the locks upwards so the pin of the lock engages a slot on
the underside of the crossbar.
CAUTION: Due to the weight of the display screen and the height of
the mounting crossbars, the lifting of the display should be done by
a minimum of two people.
3.
To unlock/release the screen, turn the key to release the spring
loaded pin in thelock.

6
Instruction – Position of Screen
1. To raise or lower the screen, loosen the screws on the side of the
column, reposition the frame in desired location and re-tighten all
screws.